Hyundai H-1551 User Manual [ru]

H-1551

RADIO WITH ALARM

РАДИОПРИЕМНИК

С БУДИЛЬНИКОМ

Руководство по эксплуатации Instruction manual

Instruction manual

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.

Description

1. MEM.SET/NAP/M+ button

2. ALARM1 button

3. ALARM2 button

4. DIMMER/SNOOZE/SLEEP button

5. TEMP/CLK.ADJ button

6. ALARM Y-M-D/ button

7. ALARM DST/C-F/ button

8. VOL+/DISPLAY button

9. button

10. VOL- button

11. Display

Not indicated: power cord (back panel), FM antenna (back panel), temperature sensor (back
panel), battery compartment (bottom), RESET button hole (bottom).

1 2 3

4 5 6

11

8

7

10

9

Utilization of the product

If you want to dispose this product, do not
mix it with general household waste. There is a
separate collection system for used electronic
products in accordance with legislation that
requires proper treatment, recovery and
recycling.
Please contact your local authorities for the
correct method of disposal. By doing so, you
will ensure that your disposed product
undergoes the necessary treatment, recovery
and recycling and thus prevent potential
negative effects on the environment and
human health.

2

Important safeguards

• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.

• Do not hit or drop the unit.

• Do not expose the unit to vibration,
direct sunlight, too high or low temperature or
humidity.

• If you are not going to use the unit within
a long period of time, remove the batteries to
avoid their leakage.

• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel.

Instruction manual

Power supply

Battery operation

• Insert 1 x 3 V lithium battery CR2032 (not
included) to the terminal inside the battery
compartment according to the polarity marks (+
and -). Your set will not work normally from the
battery supply, but there is now the advantage
that, in case there is a mains current failure,
your clock will continue to work. The clock
display will not light up, the clock time and
alarm setting will be held in the clock memory
by the battery back-up system.

This enables you to move the set from place to
place without re-setting the clock every time. The
battery back-up system is only meant to be used
from short temporary power failures. For longer
durations the battery may become exhausted or
there may be some deviation in accuracy.

• When the battery is exhausted, it should
be removed from the set to prevent leakage.
If you do not wish to take advantage of the
battery back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock figures
will flash when the mains are re-connected and
you must re-set the clock.

AС operation

• The appliance is for household use only.

• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.

• Insert the plug into the power supply.

• The set is now working as electronic clock.

• Press repeatedly Y-M-D/ button or
press and hold it to decrease the setting; press
repeatedly DST/C-F/ button or press and
hold it to increase the setting.

• In normal mode, press repeatedly Y-M-D/

button to switch the display between
current time, year and month and day. Each
indication will be on for 5 seconds, then the
display returns to initial mode.

Dimmer function

To adjust the brightness of the display, press
DIMMER button. You can switch between 3
positions: HIGH, NORMAL or LOW.

Reset

To reset all settings of the unit to default
settings, press the RESET hole with a pointed
object (e.g., a ballpoint pen). This measure is
needed when you changed the batteries in the
unit or if the unit does not function correctly.

Daylight saving time

Press and hold DST/C-F/ button to
switch on or off the DST (Daylight Saving
Time) mode. This enables to observe 1-hour
difference between summer and winter time.

Thermometer

Press TEMP/CLK.ADJ button to show
the current temperature. The temerature
indicatoin will be on for 5 seconds, then the
display returns to initial mode. Press DST/C-F/

button to switch between Celsius and

Fahrenheit temperature modes.

General operations

Setting the clock and calendar

• Press and hold CLK.ADJ button. Press it
repeatedly to cycle through time and calendar
settings in following order: Year => Month =>
Day => 12/24H mode => Current hours =>
Current minutes. The selected setting will blink.

Nap function

In normal mode press and hold MEM.SET/
NAP/M+ button to switch on or off. Press the
button to select the time period (10-90min with
a 10min step), after wich the alarm will ring.

The buzzer is used as the sound source.

Display functions

In clock mode press and hold VOL+/

3

Instruction manual

DISPLAY button to enable the cyclic changing
of time, date an temperature on the display.
Press and hold the button to disable this
function.

Radio operation

Tuner operations

• Press button to turn the radio on or off.

• Adjust the program by pressing Y-M-D/

and DST/C-F/ buttons.

• Use VOL+/- buttons to adjust volume level.

• To obtain better FM signal reception,

extend the FM wire antenna to its full length.

• Press and hold MEM.SET/NAP/M+ button
to save the selected station in the memory.
After the number of the channel begins to flash
, choose one of the 10 and press the button
one more time.

Sleep to music

• In Radio mode, press SNOOZE/SLEEP
button to turn on sleep mode. The default sleep
time of 90 minutes will be set. Press this button
repeatedly to select 60, 30 or 15 minutes of
sleep time period. The figures will blink on
the display for 5 seconds. The radio will turn
off automatically after the preset time period
elapses.

• To cancel the sleep function, select “Off“.

If you choose radio, select the volume of the
alarm from 1 to 15. The device will play the last
used channel). The selected setting will blink.

• Press repeatedly Y-M-D/ button or
press and hold it to decrease the setting; press
repeatedly DST/C-F/ button or press and
hold it to increase the setting.

• In normal mode, press repeatedly
ALARM1/2 button to show the alarm settings.

Snooze control

• When the alarm time comes, the signal will
sound for 30 minutes if no button is pressed.
After that the sound will mute and start at the
same time the following day.

• When the alarm is on, press SNOOZE/
SLEEP button to interrupt the alarm signal.
After 9 minutes the alarm will be on again.

• If you want to stop the alarm, press
button. The alarm will resume in 24 hours.

When the alarm goes off (in case radio is
chosen as a sound source), the volume cannot
be adjusted. Turn off the alarm and then turn
on the radio again to adjust volume.

Maintenance and care

Switch off the appliance, unplug from the
power supply. The outside of the appliance can
be cleaned with a slightly damp cloth.

Alarm operation

Setting the alarm

• Press the ALARM1 button in clock mode.
Press and hold ALARM1 button. Press it
repeatedly to cycle through alarm settings
in following order: Alarm 1 hours => Alarm 1
minutes => Alarm 1 days (“1-5“ - Monday ­Friday, “1-1” - choose the day, “1-7“ - Monday

- Sunday, “6-7“ - only on Saturday and Sunday.
Please adjust the calendar before setting the
alarm)=> Alarm 1 sound (buzzer and radio.

4

Accessories

Receiver 1 pc
Instruction manual 1 pc
Warranty card 1 pc
Consumer information 1 pc