H-1547
RADIO WITH ALARM
РАДИОПРИЕМНИК
С БУДИЛЬНИКОМ
Руководство по эксплуатации Instruction manual
Instruction manual Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.
Description
Front and right panels
1. Display
2. VOLUME regulator
Top panel
3. Memory card slot
4. USB port
5. PRE./TUN. button
6. STOP button
7. /CLOCK/ALARM- button
8. /CLOCK/ALARM+ button
9. PROG button
10. ALARM MODE switch
11. SNOOZE/SLEEP OFF button
12. SLEEP button
13. TIME button
14. ALARM button
15. DISPLAY/RANDOM/SCAN buttons
1 2
Not indicated: battery compartment (bottom
panel), AC input (back panel), wire FM antenna
(back panel)
2 3
3 4 5 6 7 8 9
10 11 12 13 14 15
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration,
direct sunlight, too high or low temperature or
humidity.
• If you are not going to use the unit within
a long period of time, remove the batteries to
avoid their leakage.
• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel.
Power supply
Battery operation
• Insert 1 battery Cr2032 (included) to the
battery compartment (remove the screw). The
set will not work normally from the battery
supply, but there is now the advantage that, in
case there is a mains current failure, your clock
will continue to work. The clock display will not
light up, the clock time will be held in the clock
memory by the battery back-up system. This
enables you to move the set from place to place
without re-setting the clock every time. The
battery back-up system is only meant to be used
from short temporary power failures. For longer
durations the battery may become exhausted or
there may be deviation in accuracy.
• When the battery is exhausted, it should
be removed from the set to prevent leakage.
If you do not wish to take advantage of the
battery back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock figures
will flash when the mains are re-connected and
you must re-set the clock.
AС operation
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds to the mains voltage in your home.
• Plug the corresponding end of cord into
the power socket on the rear of the set.
• Insert the plug into power supply.
Setting the clock
Set ALARM MODE switch to BUZZER
position. Press and hold TIME button until
hour digits flash. Press repeatedly /CLOCK/
ALARM- and /CLOCK/ALARM+ buttons to
set hours. Press TIME button to save hours;
minute digits will flash. Press repeatedly
/CLOCK/ALARM- and /CLOCK/ALARM+
buttons to set minutes. Press and hold TIME
button to save minutes.
Radio operation
Tuner operations
• Set ALARM MODE switch to RADIO
position; the Radio indicator on the display will
light up.
• Press TIME button to switch on the radio.
• Press RANDOM/SCAN button once to
begin searching and saving of up to 40 radio
stations automatically.
• Briefly press
or /CLOCK/ALARM+ button to select
previous or next preset station.
• Press and hold for 3 seconds
ALARM- button or /CLOCK/ALARM+ button
for automatical search of the nearest station
with strong signal down or up the range.
• Press PRE./TUN. button to switch between
radio frequency and preset position; when
frequency is displayed you can tune stations
manually with
CLOCK/ALARM+ buttons.
• To save a station, press and hold PROG
button until display blinks, press
ALARM- button or /CLOCK/ALARM+ button
to change preset position, briefly press PROG
/CLOCK/ALARM- button
/CLOCK/
/CLOCK/ALARM- and /
/CLOCK/
Instruction manual
button to save.
• Press repeatedly DISPLAY button; it will
show radio frequency/clock time/alarm time.
• Use VOLUME regulator to adjust volume
level.
• To obtain better FM-signal reception,
extend the FM-wire antenna to its full length.
• To turn off the radio press ALARM button.
Sleep to music
The radio or MP3 (if a USB/SD/MMC is
connected) can be set to play and to switch off
automatically after a preset time.
• Slide ALARM MODE switch to a position
to select MP3/USB/SD or RADIO to play.
• Press SLEEP button repeatedly to select
the sleep time period (from 90 to 0 minutes).
• MP3 playback or radio will stop
automatically after the preset time expires.
• To turn off the radio or MP3 before sleep
time expires, press SNOOZE/SLEEP OFF
button or ALARM button once.
Alarm operation
Setting the alarm
• Set ALARM MODE switch to Buzzer,
Radio or MP3/USB/SD position to select alarm
signal sound.
• Press and hold ALARM button until hour
digits flash. Press repeatedly /CLOCK/
ALARM- and /CLOCK/ALARM+ buttons to
set alarm hours. Press ALARM button to save
hours; minute digits will flash. Press repeatedly
/CLOCK/ALARM- and /CLOCK/ALARM+
buttons to set alarm minutes. Press and hold
ALARM button to save minutes.
• Press ALARM button to switch on or off
the alarm mode. The Alarm indicator will light
up when the alarm mode is on.
• To check alarm time press DISPLAY button.
Alarm sound setting
• When radio is selected for alarm sound,
select a band, tune to the needed frequency
and adjust volume.
• When USB/SD playback is selected for
alarm sound, ensure that USB or memory card
is inserted and track playback is possible.
Snooze control
• When the alarm is on, press SNOOZE/
SLEEP OFF button once, after 9 minutes the
alarm will be on again. This operation can be
repeated several times.
• When the alarm is on, press ALARM
button once to stop the alarm. The alarm will
be activated after 24 hours. Press ALARM 2
times, alarm will be completely off and Alarm
indicator goes off.
• When the buzzer alarm is on, if you don’t
press ALARM button, the buzzer will turn
off after 2 minutes, then start again after 9
minutes. This will repeat 5 times or until you
press ALARM button. When radio or MP3
alarm is on, if you don’t press ALARM button, it
will stop after 90 minutes.
USB/SD/MMC operation
Playback
• Insert a USB device into the USB port
or insert an SD/MMC memory card into the
memory card slot.
• Slide ALARM MODE switch to MP3/USB/
SD position.
• Press TIME button to switch on the player.
Playback of the first track contained in the
USB/memory card will start automatically. MP3
indicator will be flashing.
• The display starts by showing total number
of available tracks, then track number to be
played for about 2 seconds each and for every
beginning of a track. Press DISPLAY button
to change display in following order: total
available tracks/track number/track current
time/track remaining time/alarm time/clock time.
• Press PRE./TUN. button to pause
playback. Press it again to resume playback.
• Press STOP button once to stop playback;
4