Hyundai H-1546 User Manual [ru]

H-1546

RADIO WITH ALARM

РАДИОПРИЕМНИК

С БУДИЛЬНИКОМ

Руководство по эксплуатации Instruction manual

Instruction manual Instruction manual

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in future.

Description

Top panel

1. USB port

2. Memory card slot

3. PLAY/PAUSE button

4. STOP button

5. /CLOCK/ALARM- button

6. /CLOCK/ALARM+ button

7. REP1 button

8. ALARM MODE switch

9. SNOOZE/SLEEP OFF button

10. SLEEP button

11. TIME button

12. ALARM button

13. DISP/RAN switch

1 2 3 4 5 6 7

8 9 10 11 12 13

Right panel

14. TUNING regulator

15. BAND switch

16. VOL regulator

Not indicated: battery compartment (bottom

panel), AC input (back panel), wire FM antenna (back panel), dial scale (front panel), display (front panel)

2 3

14 15 16

Important safeguards

• The instruction manual contains important operating and maintenance instructions. For your safety, it is necessary to refer the manual. Keep the manual for use in future.

• Do not hit or drop the unit.

• Do not expose the unit to vibration, direct sunlight, too high or low temperature or humidity.

• If you are not going to use the unit within a long period of time, remove the batteries to avoid their leakage.

• Do not disassemble the unit yourselves. Refer servicing to qualified service personnel.

Power supply

Battery operation

• Insert 1 battery Cr2032 (included) to the battery compartment (remove the screw). The set will not work normally from the battery supply, but there is now the advantage that, in case there is a mains current failure, your clock will continue to work. The clock display will not light up, the clock time will be held in the clock memory by the battery back-up system. This enables you to move the set from place to place without re-setting the clock every time. The battery back-up system is only meant to be used from short temporary power failures. For longer durations the battery may become exhausted or there may be deviation in accuracy.

• When the battery is exhausted, it should be removed from the set to prevent leakage. If you do not wish to take advantage of the battery back-up system, your set will work normally without a battery. However, if disconnected from the mains, the clock figures will flash when the mains are re-connected and you must re-set the clock.

AС operation

• Before the first connecting of the appliance

check that voltage indicated on the rating label corresponds to the mains voltage in your home.

• Plug the corresponding end of cord into

the power socket on the rear of the set.

• Insert the plug into power supply.

Setting the clock

Set ALARM MODE switch to BUZZER position. Press and hold TIME button until hour digits flash. Press repeatedly /CLOCK/ ALARM- and /CLOCK/ALARM+ buttons to set hours. Press TIME button to save hours; minute digits will flash. Press repeatedly /CLOCK/ALARM- and /CLOCK/ALARM+ buttons to set minutes. Press and hold TIME button to save minutes.

Radio operation

Tuner operations

• Set ALARM MODE switch to RADIO position; the Radio indicator on the display will light up.

• Press TIME button to switch on the radio.

• Slide BAND switch to AM, SW or FM position.

• Adjust the frequency by using TUNING regulator.

• Use VOL regulator to adjust volume level.

• To obtain better FM signal reception, extend the FM wire antenna to its full length.

• This unit is equipped with a built-in AM antenna. Select the best orientation of this unit to get a better reception of AM signal.

• To turn off the radio press ALARM button.

Sleep to music

The radio or MP3 (if a USB/SD/MMC is connected) can be set to play and to switch off automatically after a preset time.

• Slide ALARM MODE switch to a position

to select MP3/USB/SD or RADIO to play.

• Press SLEEP button repeatedly to select

Instruction manual

the sleep time period (from 90 to 0 minutes).

• MP3 playback or radio will stop

automatically after the preset time expires.

• To turn off the radio or MP3 before sleep time expires, press SNOOZE/SLEEP OFF button or ALARM button once.

Alarm operation

Setting the alarm

• Set ALARM MODE switch to Buzzer, Radio or MP3/USB/SD position to select alarm signal sound.

• Press and hold ALARM button until hour digits flash. Press repeatedly ALARM- and set alarm hours. Press ALARM button to save hours; minute digits will flash. Press repeatedly

/CLOCK/ALARM- and /CLOCK/ALARM+ buttons to set alarm minutes. Press and hold ALARM button to save minutes.

• Press ALARM button to switch on or off the

alarm mode. The Alarm indicator will light up.

• To check alarm time press DISP/RAN

button.

/CLOCK/ALARM+ buttons to

/CLOCK/

Alarm sound setting

• When radio is selected for alarm sound, select a band, tune to the needed frequency and adjust volume.

• When USB/SD playback is selected for alarm sound, ensure that USB or memory card is inserted and track playback is possible.

Snooze control

• When the alarm is on, press SNOOZE/ SLEEP OFF button once, after 9 minutes the alarm will be on again. This operation can be repeated several times.

• When the alarm is on, press ALARM button once to stop the alarm. The alarm will be activated after 24 hours. Press ALARM twice, the alarm will be completely off and Alarm indicator goes off.

• When the buzzer alarm is on, if you don’t

press ALARM button, the buzzer will turn off after 2 minutes, then start again after 9 minutes. This will repeat 5 times or until you press ALARM button. When radio or MP3 alarm is on, if you don’t press ALARM button, it will stop after 90 minutes.

USB/SD/MMC operation

Playback

• Insert a USB device into the USB port or insert an SD/MMC memory card into the memory card slot.

• Slide ALARM MODE switch to MP3/USB/ SD position.

• Press TIME button to switch on the player. Playback of the first track contained in the USB/memory card will start automatically. MP3 indicator will be flashing.

• The display starts by showing total number of available tracks, then track number to be played for about 2 seconds each and for every beginning of a track. Slide DISP/RAN switch to DISP position (leftward) to change display in following order: total available tracks/track number/track current time/track remaining time/ alarm time/clock time.

• Press PLAY/PAUSE button to pause playback. Press it again to resume playback.

• Press STOP button once to stop playback; now playback can be started only from the first track.

• Press BACK button or NEXT button to go to previous or next track. Press and hold these buttons to fast rewind or fast forward correspondingly.

• Press REP1 button once (“0nE” will be displayed), current track will be played repeatedly. Press one more time (“rEP ALL” will be displayed), all tracks will be repeated, When “0nE” is activated, selecting previous and next track is unavailable. Repeat playback is unavailable when random playback is on.

• Slide DISP/RAN switch to RAN position (rightward); “rAn0” will be displayed, tracks will

+ 7 hidden pages