Hyundai H-1545 User Manual [ru]

H-1545
RADIO WITH ALARM
РАДИОПРИЕМНИК
С БУДИЛЬНИКОМ
Руководство по эксплуатации Instruction manual
Instruction manual Instruction manual
Dear customer!
Description
Top panel
1. button
2. button
3. USB port (under plastic cover)
4. button
5. HOUR button
6. ALARM button
7. TIME button
8. SNOOZE button
9. SLEEP button
10. MIN button
11. Projector
1 2 3 4 5
Not indicated: focus regulator (on the projector), TIME button (on the projector), MIN button (on the projector), HOUR button (on the projector)
6 7 8 9 10 11
Front panel
12. Display
13. PROJECTION ON/OFF switch
14. Dial scale
15. ON/OFF/AUTO switch
16. VOLUME regulator
17. USB/FM/AM switch
18. TUNING regulator
Not indicated: battery compartment (back panel), power cord (back panel), wire FM antenna (back panel), line input (left panel)
2 3
12
13
14
15
16
17
18
Important safeguards
• The instruction manual contains important operating and maintenance instructions. For your safety, it is necessary to refer the manual. Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration, direct sunlight, too high or low temperature or humidity.
• If you are not going to use the unit within a long period of time, remove the batteries to avoid their leakage.
• Do not disassemble the unit yourselves. Refer servicing to qualified service personnel.
Power supply
Battery operation
• Insert 1 x 9 V battery 6F22 type (not included) to the terminal inside the battery compartment. The set will not work normally from the battery supply, but there is now the advantage that, in case there is a mains current failure, your clock will continue to work. The clock display will not light up, the clock time will be held in the clock memory by the battery back-up system. This enables you to move the set from place to place without re­setting the clock every time. The battery back­up system is only meant to be used from short temporary power failures. For longer durations the battery may become exhausted or there may be some deviation in accuracy.
• When the battery is exhausted, it should be removed from the set to prevent leakage. If you do not wish to take advantage of the battery back-up system, your set will work normally without a battery. However, if disconnected from the mains, the clock figures will flash when the mains are re-connected and you must re-set the clock.
AС operation
• The appliance is for household use only.
• Before the first connecting of the appliance check that voltage indicated on the rating label corresponds the mains voltage in your home.
• Insert the plug into the power supply.
• The set is now working as an electronic clock. Figures will blink on the display, showing that you should set the clock.
Setting the clock
• Press and hold TIME button.
• Do not release TIME button; press HOUR button or MIN button to set the clock display to the correct time.
• Release all the buttons when finished the setting.
Radio operation
Tuner operations
• Slide ON/OFF/AUTO switch to ON position to turn on the radio.
• Slide USB/FM/AM switch to AM or FM position.
• Adjust the frequency by using TUNING regulator.
• Use VOLUME regulator to adjust volume level.
• To obtain better FM signal reception, extend the FM wire antenna to its full length.
• This unit is equipped with a built-in ferrite antenna. Select the best orientation of this unit to get a better reception of AM signal.
• To turn off the radio set ON/OFF/AUTO switch to OFF position.
Sleep to music
The radio or USB (if a USB device is connected) can be set to play and to switch off automatically after a preset time.
• Slide USB/FM/AM switch to a position to
select USB or radio band to play.
Instruction manual
• Slide ON/OFF/AUTO switch to OFF or
AUTO position.
• Press SLEEP button once. You can have 59 minutes playing the radio to accompany you to sleep.
• To set for a desired period of sleep (maximum 1 hour 59 minutes), simply press and hold SLEEP button and then press HOUR button or MIN button to set the desired period of the sleep function.
• USB playback or radio will stop automatically after the preset time expires.
• To turn off the radio before sleep time expires, press SNOOZE button or SLEEP button once.
Alarm operation
Setting the alarm
• Press and hold ALARM button.
• Without releasing ALARM button, press HOUR button or MIN button to set the desired wake up time.
• Release ALARM button to show the current time.
Alarm sound setting
• Turn on the radio, select a band a tune to the needed frequency. Slide ON/OFF/AUTO switch to AUTO position. Set the alarm time. The radio will start to play when the alarm time comes.
• Slide ON/OFF/AUTO switch to AUTO position. Rotate VOLUME regulator towards minimum level until a click. Set the alarm time. The buzzer will sound when the alarm time comes.
• Connect a USB device and set the USB/ FM/AM switch to USB position. Slide ON/OFF/ AUTO switch to AUTO position. Set the alarm time. The USB playback will start when the alarm time comes.
Snooze control
• When the alarm is on, press SNOOZE
button once, after approximately 9 minutes the alarm will be on again. This operation can be repeated several times within 59 minutes.
• If you want to stop the alarm, slide ON/
OFF/AUTO switch to OFF position.
USB operation
Playback
• Lift the plastic cover on the top panel and
insert a USB device into the USB port.
• Slide USB/FM/AM switch to USB position.
• Slide ON/OFF/AUTO switch to ON position. Playback of the first track contained in the USB will start automatically.
• Press the button again to resume playback.
• Press previous or next track.
• Slide ON/OFF/AUTO switch to OFF position to stop playback and turn off the USB mode.
button to pause playback. Press
button or button to go to
General USB notes
• This unit is equipped with a USB socket that can accept and play MP3 files stored on standard USB flash (compatible with USB version 2.0 and 1.1) up to 8 Gb.
• FAT32 file system is supported by USB system of this unit.
Always switch off the unit before removing a USB flash drive to prevent damage to your USB device.
Note: Although this product is fully
compatible with USB 2.0 and 1.1 standard format, a small percentage of USB flash drives might not be readable, due to those device manufacturers’ non-compliance with the full (official) USB standards.
Laser projection
• The unit is equipped with a laser projection
with individual time setting.
• Slide PROJECTION ON/OFF switch to ON
4
Loading...
+ 7 hidden pages