Hyundai H-1543 User Manual [ru]

H-1543

RADIO WITH ALARM

РАДИОПРИЕМНИК

С БУДИЛЬНИКОМ

Руководство по эксплуатации Instruction manual

Instruction manual Instruction manual

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.

Description

1. TIME button

2. DIMMER switch

3. SNOOZE button

4. ON/OFF/AUTO/ALARM switch

5. SLEEP button

6. HOUR button

7. ALARM button

8. MIN button

9. VOL regulator

10. FM/AM switch

11. TUNING regulator

1 2 3 4 5 6

7 8

9

Not indicated: battery compartment (back
panel), power cord (back panel), LED display
(front panel), dial scale (front panel), FM wire

antenna (back panel)

Important safeguards

• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.

• Do not hit or drop the unit.

• Do not expose the unit to vibration, direct
sunlight, too high or low temperature or humidity.

• If you are not going to use the unit within
a long period of time, remove the batteries to
avoid their leakage.

• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel.

2 3

10

11

Power supply

Battery operation

• Insert 1 x 9 V battery (not included) to the
terminal inside the battery compartment. Your
set will not work normally from the battery
supply, but there is now the advantage that, in
case there is a mains current failure, your clock
will continue to work. The clock display will not
light up, the clock time will be held in the clock
memory by the battery back-up system.

This enables you to move the set from place
to place without re-setting the clock every time.
The battery back-up system is only to be used

from short temporary power failures. For longer
durations the battery may become exhausted
or there may be some deviation in accuracy.

• When the battery is exhausted, it should
be removed from the set to prevent leakage.
If you do not wish to take advantage of the
battery back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock figures
will flash when the mains are re-connected and
you must re-set the clock.

AС operation

• The appliance is for household use only.

• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.

• Insert the plug into the power supply.

• The set is now working as an electronic
clock.

General operations

Setting the clock

• Press and hold TIME button.

• Do not release TIME button; press HOUR
button or MIN button to set the clock display to
the correct time.

• Release all the buttons when finished the
setting.

Dimmer function

To adjust the brightness of the display, slide

the DIMMER switch to HI or LO position.

Radio operation

• Use VOL regulator to adjust volume level

of the sound.

• To obtain better FM signal reception,

extend the FM wire antenna to its full length.

• The AM signal is picked up through the
built-in antenna. The unit should be placed to a
position for the best reception.

• To switch off the radio slide ON/OFF/
AUTO/ALARM switch to OFF position.

Sleep to music

The radio can be set to play and to switch off

automatically after a preset time.

• Slide ON/OFF/AUTO/ALARM switch to
OFF or AUTO position.

• Press SLEEP button once to set 59
minutes of sleep time.

• To set for a desired period of sleep
(maximum 1 hour 59 minutes), press and hold
SLEEP button and then press HOUR button
or MIN button to set the desired period of the
sleep function.

• To turn off the radio before sleep time
expires, press SNOOZE button once.

Alarm operation

Setting the alarm

• Press and hold ALARM button.

• Without releasing ALARM button, press
HOUR button or MIN button to set the desired
wake up time.

• Release ALARM button to show the
current time.

• Slide ON/OFF/AUTO/ALARM to AUTO
position. The radio will play automatically at the
preset time.

Tuner operations

• Slide ON/OFF/AUTO/ALARM switch to ON

and turn on the volume.

• Slide FM/AM switch to AM or FM position.

• Adjust the program using TUNING

regulator.

Alarm sound setting

Follow the steps of “Setting the alarm” and
slide ON/OFF/AUTO/ALARM switch to ALARM
position. You will be awakened by the buzzer
alarm.