Hyundai H-1541 User Manual [ru]

H-1541

RADIO WITH ALARM

РАДИОПРИЕМНИК

С БУДИЛЬНИКОМ

Руководство по эксплуатации Instruction manual

Instruction manual Instruction manual

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.

Description

1. BAND button

2. TEMP/ button

3. Y-M-D/ button

4. AL.1 button

5. DIMMER switch

6. SNOOZE/SLEEP button

7. LIGHT switch

8. AL.2 button

9. AL.SET button

10. MODE button

11. button

Not indicated: power cord (back panel), FM antenna (back panel), temperature sensor (back
panel), line input (back panel), battery compartment (bottom), TUNER regulator (right panel),
VOLUME regulator (right panel), RESET button hole (left panel), display (front panel).

1 2 3 4 5 6 7 8 9 10 11

Important safeguards

• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.

• Do not hit or drop the unit.

• Do not expose the unit to vibration,
direct sunlight, too high or low temperature or
humidity.

• If you are not going to use the unit within
a long period of time, remove the batteries to
avoid their leakage.

• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel.

2 3

Power supply

Battery operation

• Insert 1 x 3 V lithium battery CR2032 (not
included) to the terminal inside the battery
compartment according to the polarity marks (+
and -). Your set will not work normally from the
battery supply, but there is now the advantage
that, in case there is a mains current failure,
your clock will continue to work. The clock
display will not light up, the clock time and
alarm setting will be held in the clock memory
by the battery back-up system.

This enables you to move the set from place to
place without re-setting the clock every time. The
battery back-up system is only meant to be used
from short temporary power failures. For longer

durations the battery may become exhausted or
there may be some deviation in accuracy.

• When the battery is exhausted, it should
be removed from the set to prevent leakage.
If you do not wish to take advantage of the
battery back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock figures
will flash when the mains are re-connected and
you must re-set the clock.

AС operation

• The appliance is for household use only.

• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.

• Insert the plug into the power supply.

• The set is now working as electronic clock.

General operations

Setting the clock and calendar

• Press and hold MODE button. Press it
repeatedly to cycle through time and calendar
settings in following order: Year => Month =>
Day => 12/24H mode => Current hours =>
Current minutes. The selected setting will blink.

• Press repeatedly TEMP/
press and hold it to decrease the setting; press
repeatedly Y-M-D/
it to increase the setting.

• In normal mode, press repeatedly Y-M-D/

button to switch the display between
current time, year and month and day. Each
indication will be on for 5 seconds, the the
display returns to initial mode.

button or press and hold

button or

Dimmer function

To adjust the brightness of the display, slide

DIMMER switch to HIGH or LOW position.

Bottom backlight

To switch on/off backlight of the unit bottom,

slide LIGHT switch to ON or OFF position.

Reset

To reset all settings of the unit to default
settings, press the RESET hole with a pointed
object (e.g., a ballpoint pen). This measure is
needed when you changed the batteries in the
unit or if the unit does not function correctly.

Daylight saving time

Press and hold Y-M-D/ button to
switch on or off the DST (Daylight Saving
Time) mode. This enables to observe 1-hour
difference between summer and winter time.

Thermometer

Press TEMP/ button to show the current
temperature. The temerature indicatoin will
be on for 5 seconds, the the display returns to
initial mode. Press and hold TEMP/ button
to switch between Celsius and Fahrenheit
temperature modes.

Line input

• You can connect the audio output of an
external device to this unit, to listen to the
sound of that device through the amplifier of
this unit.

• To connect an external audio device (eg.
MP3 player), please use a standard stereo
cable (not included) with 3.5 mm to 3.5 mm
plugs to connect the headphone out or audio
line-out of the external device to the Line input
socket of this unit.

Radio operation

Tuner operations

• Press button to turn the radio on or off.

• Press BAND button to switch between AM
and FM radio bands.

• Adjust the program by rotating TUNER
regulator.

• Use VOLUME regulator to adjust volume
level.

• To obtain better FM signal reception,