Hyundai H-1509 User Manual [ru]

H-1509

ALARM CLOCK RADIO

РАДИОПРИЕМНИК

С БУДИЛЬНИКОМ

Руководство по эксплуатации Instruction manual

Instruction manual Instruction manual

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read this
manual carefully before connecting, operating and/or adjusting the product and keep the manual
for reference in future.

Description

1. SLEEP button

2. ALM button

3. TIME button

4. MIN button

5. Dial scale

6. Display

7. SNOOZE button

8. HOUR button

9. TUNING regulator

10. BAND switch

11. VOLUME regulator/Buzzer

Not indicated:

battery compartment (bottom panel)
AUTO/OFF/ON switch (back panel)
FM antenna (back panel)
Power cord (back panel)
DIMMER switch (back panel)

1 2 3 4

5 6 7 8 9 10 11

Important safeguards

• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.

• Do not hit or drop the unit.

• Do not expose the unit to vibration,
direct sunlight, too high or low temperature or
humidity.

• If you are not going to use the unit within
a long period of time, remove the batteries to
avoid their leakage.

• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel.

2 3

Power supply

Battery operation

• Insert 1x9V battery (not included) to the
terminal inside the battery compartment. Your
set will not work normally from the battery
supply, but there is now the advantage that, in
case there is a mains current failure, your clock
will continue to work. The clock display will not
light up, the clock time will be held in the clock
memory by the battery back-up system.

This enables you to move the set from place
to place without re-setting the clock every time.
The battery back-up system is only meant to
be used from short temporary power failures.
For longer durations the battery may become

exhausted or there may be some deviation in
accuracy.

• When the battery is exhausted, it should
be removed from the set to prevent leakage.
If you do not wish to take advantage of the
battery back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock figures
will flash when the mains are re-connected and
you must re-set the clock.

AС operation

• The appliance is for household use only.

• Before the first connecting of the unit
check that voltage indicated on the rating label
corresponds the mains voltage in your home.

• Insert the plug into the power supply.

• The set is now working as an electronic
clock. Figures will blink on the display showing
that clock should be set.

Setting the clock

• Press and hold TIME button.

• Do not release TIME button; press HOUR
button or MIN button to set the clock display to
the correct time.

• Release all the buttons when finished the
setting.

Radio operation

Tuner operations

• Slide AUTO/OFF/ON switch to ON position.

• Slide BAND switch to AM or FM position to
select the needed band.

• Use VOLUME regulator to adjust volume
level.

• Adjust the program using TUNING
regulator.

Antenna

• For AM reception, the unit is equippped
with a built-in sensitive ferrite antenna.

• For FM reception, the unit is equipped with
an external wire antenna. Be sure to untwist

the antenna to its fullest length for a better
reception.

Sleep to music

The radio can be set to play and to switch
off automatically after a preset time. Minimal
time is 1 minute, maximal period is 1 hour 59
minutes.

• Slide AUTO/OFF/ON switch to AUTO

position.

• To set for a desired period of sleep, press
and hold SLEEP button and, without releasing
it, press MIN or HOUR button to set the desired
period of the sleep time.

• If you want to turn off the radio before sleep
time expires, press SNOOZE button.

Alarm operation

Setting the alarm

• Slide AUTO/OFF/ON switch to AUTO
position.

• Press and hold ALM button.

• Without releasing ALM button, press
HOUR button and MIN button to set the
desired wake up time.

• Release ALM button to show the current
time.

• The radio will play automatically at the
preset time. To switch the alarm off, press ALM
button.

• The preset wake up time will be saved
in the memory of the unit, and the alarm will
sound at the same time next day.

Alarm sound setting

Follow the steps of “Setting the alarm”
and set VOLUME regulator to Buzz position.
You will be awakened by the buzzer alarm.
The buzzer can be switched by pressing
ALM button, or you can switch the buzzer to
radio by setting AUTO/OFF/ON switch to ON
position.

Snooze control

When the alarm is on, press SNOOZE button
once, after approximately 9 minutes the alarm
will be on again.