Hyundai H-1444 Instruction Manual

H-1444

CD/MP3/USB RADIO PLAYER	CD/MP3/USB-
WITH IPOD/IPHONE DOCKING	СТЕРЕОМАГНИТОЛА
	С ПОДДЕРЖКОЙ IPOD/IPHONE

Instruction manual

Руководство по эксплуатации

Instruction manual

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in future.

Description
Main unit	1
	2
	3
	4
	5	18
	6	19
	7	20
		21
		22

		8		9	10 11 12 13 14 15 16					17
1.	Telescopic FM-antenna				15.		FM stereo indicator
2.	Handle				16.				button
3.	CD compartment cover				18.		OPEN/CLOSE button
4.	USB port				19.				USB button
5.	Standby indicator				20.		STOP button
6.	POWER button				21.		TUNING regulator
7.	REP/RAN button				22.				button
8, 17. Speakers						Not indicated:
9.	PROG button
10.		BASS button				Back panel: Power cord socket, AUX input,
11.		IR sensor				Phone output
12. iPod jack compartment						Bottom: Battery compartment
13.		LCD display				Left panel: VOL regulator, Function switch
14.		BASS indicator				Right panel: Band switch

2

Instruction manual

Remote controller (RC)
	Utilization of the product

1
2	8
3
4	9
5
6
7	10

1.PROGRAM button

2.-10/FOL- button

3.USB button

4.button

5.STOP button

6.REPEAT/RANDOM button

7.VOLbutton

8.+10/FOL+ button

9.button

10.VOL+ button

RC power and operation

•Open the battery cover on the rear of the Remote controller. Insert 2 AAA batteries (not included) correctly so that the + and - polarities math the diagrams inside the battery compartment.

•When the batteries are exhausted, replace them with new batteries for normal operation. Remove the batteries if the RC is not in use for a long time.

•The operating distance between the RC and the main unit is up to 6 m, the operation angle is not more than 300.

•The RC buttons are functional for CD/ MP3/USB operations only.

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Please contact your local authorities for the correct method of disposal. By doing so, you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health.

Important safeguards

•Attention: The owner’s manual contains important operating and maintenance instructions. For your safety, it is necessary to refer to the manual.

•Dangerous voltage: Uninsulated dangerous voltage that may be of sufficient magnitude to constitute a risk of electrical shock to persons is present within this product enclosure.

•Caution: To reduce the risk of electric shock, do not dismantle the body. Prefer servicing to qualified service personnel. Do not use the unit in places where it can be exposed to water, moisture and dust. Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctions, or create safety hazards such as electrical shock.

Power supply

Battery operation

•Open the battery compartment cover.

•Insert 6 x UM-2/C/R-14 size batteries (not included). Please observe correct battery polarities or the set will not work.

3

Instruction manual

• Close the battery compartment cover.

AC operation

•Before the first connecting of the appliance check that voltage indicated on the rating label corresponds the mains voltage in your home.

•Plug the corresponding end of supplied cord into the power cord socket of this unit.

•Insert the plug into power supply.

Caution:

•When the set is only used with AC or is not used for 2 weeks or more, please remove the batteries, to avoid damage to the set from leakage of batteries.

•Always switch off the unit when not in use.

•Always unplug the appliance from power supply, when no use long time.

Switch on/off

Press POWER button on the unit to switch it from standby mode. Standby indicator will go out. When the unit is on, press POWER button to switch the unit off to standby mode; Standby indicator will light up with red color.

Headphone jack

•For private listening, insert 3.5 mm headphone into the Phone jack.

•Adjust volume to the appropriate level as desired.

•When the stereo headphone jack is plugged, speaker will disconnect automatically.

AUX line in jack

You can connect the audio output of an external device (such as a CD-player) to this unit, to listen to the sound of that device through the amplifier of this unit.

• To connect an external audio device (eg. MP3 player), please use a standard stereo cable (not included) with 3.5 mm to 3.5 mm plugs to connect the headphone out or audio

line-out of the external device to the AUX input socket of this unit.

•Slide the function switch to AUX position.

•Turn on the external device.

Radio operation

•Set the function switch to RADIO position.

•Select your desired broadcasting band by setting the band switch to the desired position. AM of FM will be displayed.

•Rotate TUNING regulator to tune to your desired radio station frequency. The radio frequency will be shown on the display.

•Rotate VOL regulator to adjust sound volume level.

•To turn off the radio set the function switch to AUX position.

Antenna

•For FM reception, adjust the telescopic antenna appropriately to obtain the best reception on the band selected.

•The AM signals are picked up through the built-in antenna. The set should be placed to an appropriate position for the best reception.

FM stereo reception

•In particular when stereo signal is weak and much noise are received, it is preferable to receive programs in mono mode. Set the band switch to FM ST position to receive radio programs in stereo mode.

•If the program is received in FM stereo, the FM stereo indicator will light up.

Disc operations

Insertion and removal of discs

•Press the OPEN/CLOSE button to open the CD compartment cover. Place a disc into the compartment with the label side (printed side of disc) facing upwards.

•When the disc has been placed onto

4

Instruction manual

the center spindle, gently lower the CD-door downwards until it locks shut. The disc is now ready to be played.

•When opening the CD-door, always ensure the disc is not in motion (not spinning). Always press STOP button to stop the disc spinning first.

•To remove the disc, follow the same procedure as described above, except to remove the disc instead of inserting it into the compartment.

Always hold a disc by its edges. Avoid getting any fingerprints, smudges or dirt onto the surface of a disc. In case this happens, use a special CD-cleaning cloth or cleaning kit to remove the dirt or smudges.

Important: Please make sure to always fold down the handle before opening the CD door.

Compact disc operation

•Set function switch to CD/MP3 position.

•Put a disc into the CD compartment and close the CD door.

•The display will show the total number of tracks after a few seconds.

Play/pause mode

•PressUSB button on the unit or on the RC to start playback, the display will show the current track number and PLAY symbol.

•PressUSB button on the unit or on the RC to pause at any track when playing, PLAY symbol on the display flashes. Press this button again to resume playback.

•To stop playback, press STOP button. The display will show the total number of tracks on the disc.

Skip and search mode

•Press button on the unit or button on the RC once to skip to the next track. Press and hold this button to search for a particular point at high speed forward. Release the button to resume normal playback.

•Press button on the unit or button on the RC to go to the beginning of the

current track; press this button twice to skip back to previous track. Press and hold this button to search for a particular point at high speed backward. Release the button to resume normal playback.

•If the disc contains more than 10 tracks, you can skip to 10 tracks forward or back by pressing +10/FOL+ or -10/FOL- buttons on the RC correspondingly.

•If you use an MP3 disc containing folders, you can select a folder. In stop mode, press and hold repeatedly +10/FOL+ or -10/FOL- button on the RC. The number of the current folder will be displayed. After you selected

a folder you can select tracks in the current folder as described above. While playback, the track number and folder number will be shown every few seconds alternatively.

Repeat/Random mode

•Press once REP/RAN button on the unit or REPEAT/RANDOM button on the RC for single track repeat playing. REP will be displayed.

•Press this button again for all track repeat playing. REP ALL will be displayed.

•If you use an MP3 disc containing folders, press this button again to repeat all tracks in the current folder. REP ALBUM will be displayed.

•Press this button again for all track random playing. RANDOM will be displayed.

•To cancel repeat or random playback, press again REP/RAN button on the unit or REPEAT/RANDOM button on the RC.

Program mode

Up to 99 tracks can be programmed for disc play in any order or the same track can be repeated up to 99 times.

•Before use, be sure to stop the disc by pressing STOP button.

•Press PROGRAM button on the RC or PROG button on the unit. The display will show “P01” and “PROGRAM”. This indicates that the set is now in memory programming mode, at the first memory position.

•If you use an MP3 disc, press and hold

5