MAINTENANCE
Scheduled Maintenance Normal Usage Severe Usage*
Engine Oil & Filter Replace 7,500 Replace 3,000
Tire Rotation Perform 7,500 Perform 7,500
Fuel Lines, Fuel Hoses & Connections Inspect 7,500 Inspect Same As Normal
Steering Gear Box, Linkage & Boots/ Inspect 7,500 Inspect More Frequently
Lower Arm Ball Joint, Upper Arm Ball Joint
Suspension Mounting Bolts Inspect 7,500 Inspect Same As Normal
Vacuum Hose Inspect 7,500 Inspect Same As Normal
Vapor Hose & Fuel Filler Cap Inspect 7,500 Inspect Same As Normal
Climate Control Air Filter (For Evaporator & Replace every 12 Inspect More Frequently
Blower Unit) mos. or
10,000
Air Conditioning Refrigerant Inspect 15,000 Inspect Same As Normal
Brake Hoses & Lines Inspect 15,000 Inspect Same As Normal
Brake Pads, Calipers & Rotors Inspect 15,000 Inspect More Frequently
Drive Shaft & Boots Inspect 15,000 Inspect 7,500
Electronic Throttle Control Inspect 15,000 Inspect Same As Normal
Exhaust Pipe & Muffler Inspect 15,000 Inspect Same As Normal
Power Steering Pump, Belt & Hoses Inspect 15,000 Inspect Same As Normal
Inspect 7,500 Inspect More Frequently
Air Cleaner Filter (Engine) Replace 30,000
Inspect 15,000
Fuel Tank Air Filter Replace 30,000
Inspect 15,000 Inspect Same As Normal
Automatic Transaxle Fluid Replace 105,000 Replace 30,000
Coolant Replace Every 24 Replace Same As Normal
mos. or
30,000
Brake Fluid Inspect 30,000 Inspect Same As Normal
Crankcase Ventilation Hose Inspect 30,000 Inspect Same As Normal
Drive Belt (Autotensioner, Alt, P/Str’g, Inspect 30,000 Inspect Same As Normal
A/con, W/Pump)
Rear Disc Brake/Linings, Parking Brake Inspect 30,000 Inspect More Frequently
Fuel Filter Replace 37,500 Replace Same As Normal
Valve Clearance Inspect 60,000 Inspect Same As Normal
Spark Plugs (Iridium Coated) Replace 97,500 Replace More Frequently
*See Owner’s Manual for details.
HYUNDAI ENTOURAGE
QUICK REFERENCE GUIDE
Looking For More Detailed Information? This Quick Reference Guide does not replace your vehicle’s Owner’s
Manual. If you require additional information or are unsure of a specific issue, you should always refer to
the vehicle’s Owner’s Manual or contact your authorized Hyundai dealer.
*NP150_-_P8000*
NP150 - P8000
10/07 (rev 10/07)
www.hyundaiusa.com
Roadside Assistance: 1-800-243-7766
Consumer Affairs: 1-800-633-5151
XM Radio: 1-800-967-2346
4
5
67
40
50
60
70
80
90
100
F
E
110
H
DISC
DISC
LOAD
EQ
SCAN
INFO
CONTROLENTER
SEEK
TRACK
1
FF
4 REW
2
RDM
5 RPT
3
6 MARK
FM / AM
CD
POWER
VOLUME
AUTO
TEMP
TEMP DUAL
MODE
A/C
REAR
P
R
N
D
+
-
FRONT
VOL
VOL
MODE
COAST
SET
CANCEL
RES
ACCEL
L
R
REAR
TEMP
PUSH
TUNE
FILE
FLDR
-+
+
0
R
H
M
R
SCROLL
AUDIO
PUSH
DRIVER CONTROLS
Driver Position
Memory System*
Page 4
Power Mirror
Control
Page 5
Headlights and
Fog Lights*
Page 5
Tire Pressure
Monitoring System
(TPMS)
Page 7
Wiper / Washer
Page 8
Adjustment
Page 9
Clock
Classification
System
Page 9
Audio System*
Page 10-11
Occupant
Power Seat
Adjustment*
Page 4
2 3
2 3
Parking Brake
Release
Page 6
Adjustable
Pedals*
Page 6
Steering Wheel
Audio Controls*
Page 6
Cruise Control
Page 7
Climate Control
Page 12-14
Automatic
Transmission
Page 14
Heated Seats*
Page 14
*if equipped
DRIVER CONTROL FEATURES
OFF
ON
AUTO
OFF
OFF
ON
AUTO
OFF
OFF
ON
AUTO
OFF
L
R
2
1
M
AUTO
2
1
M
AUTO
POWER MIRROR CONTROL
The switch is located on the driver’s door
panel next to the driver position memory
DRIVER POSITION MEMORY SYSTEM (if equipped)
The Driver Position Memory System controls
are located on the driver’s side door trim.
TO SET THE MEMORIZED DRIVER POSITION:
1. Place the shift lever into P (Park) while the
ignition switch is ON.
2. Adjust the driver’s seat, outside rearview
mirrors and adjustable pedal positions to the
desired position.
3. Push the M button on the control panel until the signal beeps.
4. Within five seconds, push button 1 or 2 until the signal beeps twice. The beep
confirms that the positions are successfully memorized.
TO ACTIVATE THE MEMORIZED POSITION:
1. Place the shift lever into P (Park) while the ignition switch is ON.
2. Press button 1 or 2 to adjust seating position to memorized setting.
EASY ACCESS FUNCTION
When the AUTO button is ON (the indicator light illuminates) and the shift lever is
in the P (Park) position, the system will move the driver’s seat forward or backward
automatically so you can comfortably enter and exit the vehicle.
See the Owner’s Manual for conditions in which the Driver Position Memory System
will not operate.
POWER SEAT ADJUSTMENT (if equipped)
A
LUMBAR CONTROL
To manually adjust the lumbar support, move the lever to
the desired position.
B
SEATBACK ANGLE
To recline the seatback, tilt the control forward or backward.
C
SEAT HEIGHT AND FORWARD / BACKWARD
To adjust seat cushion height, move the control
switch according to the desired adjustment.
The front and rear sections of the cushion
can be adjusted independently.
To move the seat forward or backward,
move the control switch C accordingly.
4 5
A
B
C
system and can be used to adjust both
the left and right outside mirrors.
TO ADJUST THE POSITION OF EITHER
MIRROR:
1. Move the selecting switch to the
R (right) or L (left) to adjust the
corresponding mirror.
2. Adjust the mirror angle by
depressing the appropriate direction
on the perimeter switch.
3. Move the selecting switch to L to tilt
down both mirrors while in reverse.
4. Move the selecting switch to R to tilt
down only the right mirror.
5. Move the selecting switch back to
the middle position to deactivate the
perimeter switch.
HEADLIGHTS AND FOG LIGHTS
HEADLIGHT SWITCH
To operate the headlights, turn the
switch on the end of the lever:
OFF – Headlights are off
– Parking Lights
– Headlights
AUTO – Auto Light (if equipped)
NOTE: The ignition must be in the ON
position to turn on the headlights.
High Beam Activation: Push the
lever forward.
Flash Feature: Pull the lever toward
you and release.
FOG LIGHT SWITCH (if equipped)
Turn the switch to the ON position.
NOTE: Fog lights will only function on
low beam.
MODE
VOL
M
U
T
E
RES
ACCEL
CANCEL
•
COAST
SET
ON
OFF
PARKING BRAKE RELEASE
To release the parking brake, pull the parking
brake release lever.
ADJUSTABLE PEDALS (if equipped)
With the transmission shift lever in the P
(Park) position, turn the ignition key to ON.
Push the pedal position switch to move the
pedals toward you. Push the switch to move
the pedals away from you.
CRUISE CONTROL
To set a cruising speed:
1. ON D – Pull switch and the CRUISE
indicator in the instrument cluster will
illuminate. Accelerate to the desired
cruising speed (above 25 mph).
2. SET C – Push and remove your foot
from the accelerator pedal.
To accelerate or decelerate speed:
ACCEL A – Press to accelerate your
speed with cruising speed set.
COAST C – Press to slow speed down
with cruising speed set.
To cancel the cruising speed:
Press the CANCEL B switch, press
the brake pedal, or turn OFF D
cruise control.
A
B
D
C
TIRE PRESSURE MONITORING SYSTEM
(TPMS)
LOW TIRE PRESSURE INDICATOR:
Illuminates if one or more of your tires
is significantly under-inflated. You
should stop and check your tires as soon
as possible, and inflate them to the
proper pressure.
STEERING WHEEL AUDIO CONTROLS (if equipped)
LOW TIRE PRESSURE POSITION INDICATOR:
Indicates which tire is significantly
A
VOLUME SWITCH
Press to increase or to decrease
audio volume.
B
MODE SWITCH
Each press of the MODE switch changes
the audio mode as follows:
FM
C
SEEK SWITCH
• Tap once to navigate through radio.
• Hold to quickly scroll through audio
frequencies or fast forward / rewind through
CD/MP3 tracks.
D
MUTE SWITCH
Press the MUTE switch to turn the sound
on or off.
g AM g
XM
B
A
C
D
under-inflated by illuminating the
corresponding position light.
TPMS MALFUNCTION INDICATOR:
Illuminates and stays illuminated
when there is a malfunction with the
TPMS system. Have the system checked
by an authorized Hyundai dealer as soon
as possible.
NOTE: The TPMS is not a substitute for
proper tire maintenance, and it is the
driver’s responsibility to maintain correct
tire pressure, even if under-inflation
has not reached the level to trigger
illumination of the TPMS low tire
pressure indicator.
6 7
Loading...