Hytera Communications VM550D User Manual
Body Worn Camera
USER MANUAL
Preface
Welcome to the world of Hytera and thank you for purchasing this product. To derive optimum
performance from the product, please carefully read this manual before use.
This manual is applicable to the following product:
VM550D Body Worn Camera
1
Icon Conventions
The following icons are available through this manual:
:
Indicates references that can further describe the related topics.
:
Indicates situations that could cause data loss or equipment damage.
:
Indicates situations that could cause minor personal injury.
Copyright Information
Hytera is the trademark or registered trademark of Hytera Communications Corporation Limited (the
Company) in PRC and/or other countries or areas. The Company retains the ownership of its trademarks
and product names. All other trademarks and/or product names that may be used in this manual are
properties of their respective owners.
The product described in this manual may include the Company's computer programs stored in
memory or other media. Laws in PRC and/or other countries or areas protect the exclusive rights of the
Company with respect to its computer programs. The purchase of this product shall not be deemed to
grant, either directly or by implication, any rights to the purchaser regarding the Company's computer
programs. The Company's computer programs may not be copied, modified, distributed, decompiled, or
reverse-engineered in any manner without the prior written consent of the Company.
Disclaimer
The Company endeavors to achieve the accuracy and completeness of this manual, but no warranty of
accuracy or reliability is given. All the specifications and designs are subject to change without notice
due to continuous technological development. No part of this manual may be copied, modified,
translated, or distributed in any manner without the prior written consent of the Company.
We do not guarantee, for any particular purpose, the accuracy, validity, timeliness, legitimacy or
completeness of the third-party products and contents involved in this manual.
If you have any suggestions or would like to receive more information, please visit our website
at:
http://www.hytera.com
.
EU Regulatory Conformance
As certified by the qualified laboratory, the product is in compliance with the essential requirements and
other relevant provisions of the following directives:
2
2006/66/EC
2011/65/EU
2012/19/EU
2014/53/EU
Please note that the above information is applicable to EU countries only.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Labelling requirements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Information to User
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Specific Absorption Rate (SAR) information
3
This product meets the government's requirements for exposure to radio waves. The guidelines are
based on standards that were developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include a substantial safety margin designed to
assure the safety of all persons regardless of age or health.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a
minimum separation distance of 5mm for body worn must be maintained between the user’s body,
including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should
not contain any metallic components. Body-worn accessories that do not meet these requirements may
not comply with RF exposure requirements and should be avoided. Use only the supplied or an
approved antenna.
IC Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
SAR Warning
IC
The information listed above provides the user with information needed to make him or her aware of a
RF exposure, and what to do to assure that this radio operates within the RSS exposure limits of this
radio.
The device complies with RF specifications when the device used at 5mm from your body. Third-party
belt-clips, holsters, and similar accessories used by this device should not contain any metallic
components. Body-worn accessories that do not meet these requirements may not comply with RF
exposure requirements and should be avoided.
4
RED Statement
1. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to
the instructions.
2. The product shall only be connected to a USB interface of version USB2.0.
3. Adapter shall be installed near the equipment and shall be easily accessible.
4. The operating temperature of the EUT can't exceed 55°C and shouldn't be lower than 0°C.
5. The plug considered as disconnect device of adapter.
6. The device complies with RF specifications when the device used at 5 mm form your body.
Hereby, Hytera Communications Corporation Limited declares that this product is in compliance with
essential requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to
be used in all EU member states.
5
No.
Name
Qty.
1
Body Worn Camera
1
2
Battery
1
3
Belt Clip
1
4
USB Cable
1
5
Power Adapter
1
6
Charger
1
7
User Manual
1
Pictures listed in this manual are for reference only.
1. Packing List
Please unpack carefully and check that all items listed below are received. If any item is missing or
damaged, please contact your dealer.
6
No.
Name
No.
Name
1
Push-to-Talk (PTT) Key
10
Infrared (IR) LED
2
Video Recording Key
11
Camera Flash
3
Photo Taking Key
12
Battery Latch
4
Speaker
13
Accessory Connector (4-pin)
5
Light Sensor
14
USB Connector
6
Camera
15
Emergency Key
7
LED Indicator
16
Power On/Off Key
8
Audio/Video Recording Microphone
17
LCD Display
Keys (Menu/Back Key, Left key,
Play/Pause/Confirm Key, Right Key)
2. Product Overview
2.1 Product Layout
9 Speaking Microphone
18
7
Icon
Description
WLAN is enabled with no connection established.
WLAN is enabled and established with network connection (full
signal); the grids indicate the signal strength, the more, the stronger.
WLAN hotspot is enabled.
BT Feature is enabled.
BT connection is established.
The remaining capacity of the TF card is less than 2 GB.
The TF card is full
.
Earpiece is connected.
The product is being charged.
: Low battery.
: Full battery.
Displays the current time.
Video Recording mode.
Photo taking mode.
Audio recording mode.
Pre- or post-event recording mode.
Tagged Video.
The video is damaged.
The photo is damaged.
The audio is damaged.
2.2 LCD Icons
8
Status
Description
The product is transmitting voice or emergency alarm.
The product is being turned off.
The product is receiving voice or emergency alarm.
The product is being turned on
Glows orange
Call hang time. You can press and hold the
PTT
key to speak.
No voice transmission in emergency mode.
The remaining capacity of the TF card is less than 2 GB.
Flashes once every second: The product is recording a video.
recharge or replace the battery in time.
Flashes orange slowly
The product is recording an audio.
Flashes red and blue in turn
The product is pairing with other BT devices.
Flashes blue rapidly
BT connection is established.
Body Worn Camera
Dimensions (H×W×D)
26 mm×55 mm×85.5 mm
Weight (with battery)
144 g
Camera
Fixed angle, glass, diagonal 139°, horizontal 116°, vertical 60°.
Focus Range
0.1 m to infinity
2.3 LED Indicators
Glows red
Glows green
Flashes orange rapidly
The product is being charged.
The TF card is full.
The product is fully charged.
.
Flashes red slowly
2.4 Specifications
Flashes once every five seconds: The battery runs low. Please
9
Loading...