- 1 -
Front and Rear Parking Sensor System
4 Front and 4 Rear In-Bumper Sensors
Wired LED Display with Built-in Front Beeper and Separate Rear Beeper
For Cars, Mini-VANs, 4X4s, SUVs, and Small Trucks
(Vehicle Length Under 17 Feet)
Included in the Box
● 8x Sensors (in-bumper type) with attached
cable and 2-pin mini plug. Cable Length:
Front Sensor = 6.0m (19.6ft); Rear Sensor
= 2.5m (8.2ft)
● 1x LED Display with attached cable and
8-pin plug. Cable Length: 6.0m(19.6ft).
Two small double-sided self-adhesive
pads on bottom of the display
● 1x Rear Beeper (Black) with attached
cable (yellow, red-white). Cable Length:
2.5m (8.2ft).
● 1x Double-Sided Self-Adhesive Pad for
affixing the rear beeper to vehicle
● 1x Control Box
● 1x Double-Sided Self-Adhesive Pad with
Velcro Attachment for affixing control box
to vehicle
● 1x Power Cable for Control Box with five
wires (black, yellow, blue, white, and red)
with a 5-pin plug on one end. Length: 2.5m
(8.2ft). Note: the red wire for ACC is 7m
(23ft) with 5A fuse near the 5-pin plug
● 1x Drill Bit (Hole Saw) - Φ22.3 mm (7/8”)
● 1x User’s Manual
Features
● Front and Rear Parking Sensor System to
provide good coverage of both front and
rear end of vehicle
● 4 front and 4 rear in-bumper sensors to
give the look of factory installed system
● Wedged sensor edge to adjust for
non-vertical bumpers
● Rear sensors activated when reversing
and front sensors activated when forward
parking with braking
● Designed for cars, SUVs, 4x4s,
Mini-VANs, and small trucks (vehicle
length under 17’)
● Wired LED display with built-in front beeper
with On/Off switch. Sounds only when front
sensors are working (when forward parking)
● Separate rear beeper sounds only when rear
sensors are working (when reversing)
● Beeping faster when getting closer to
obstacle
● Seven (7) LED Lights on each side of the
display to show both orientation of obstacles
and Safe/Warning/Stop zone indicated by
blue/yellow/red LED lights
● Distance display in meters
● Limited 12 Month Warranty
Specifications (for reference only and may be changed without prior notice)
● FCC CE ISO9001 Approved
● Operating Voltage: DC +10.5 ~ +16V
● Detecting Range
Front Sensors:
E,H: 0.6m (2ft); F,G: 0.8m (2.6ft)
Rear Sensors:
A,D: 1.0m (3.3ft); B,C: 2.0m (6.6ft)
● Measuring Error: ± 0.1m
● Sensor Detection Angle: 90°
● Sensor Diameter: Φ22mm (0.87”)
● Sensor Length: 21mm (0.83”)
● Detection Response Time: 300ms
● Ultrasonic Frequency: 40Khz
● Audible Alert Volume: 60 db
● Maximum Power Consumption: 4W
● Current Consumption: 100~300mA
● Operating Temperature Range: -30 ~ +70°C
● Dimensions of the Control Box: WxDxH =
11.0cm x 8.0cm x 3.0cm (4.3" x 3.1" x 1.2")
● Dimensions of the LED Display: WxDxH =
10.0cm x 4.0cm x 2.0cm (3.9" x 1.6" x 0.8")
● Size of the rear beeper: diameter =
5.2cm(2.1"); thickness = 1.5cm(0.6")
- 10 -
Customer Service and Technical Support
For customer service and technical support, visit our Web site as listed below, then click on the
link Contact Us
.
Spare and Replacement Parts
To order spare and replacement parts for your system, visit our Web site as listed below, then
click on the link Replacement Parts
.
HY Technologies ● http://parkingsensors.net
Copyright © 2009 HY Technologies ● Milpitas ● California ● USA All Rights Re served