Memory Module Specifications
HX436C17PB4K4/32
HX436C17PB4K4/32
32GB (8GB 1G x 64-Bit x 4 pcs.)
DDR4-3600 CL17 288-Pin DIMM
B 1G x 64-Bit x 4 pcs.
SPECIFICATIONS
DESCRIPTION
HyperX HX436C17PB4K4/32 is a kit of four 1G x 64-bit (8GB)
DDR4-3600 CL17 SDRAM (Synchronous DRAM) 1Rx8,
memory module, based on eight 1G x 8-bit FBGA components
per module. Each module kit supports Intel® Extreme
Memory Profiles (Intel® XMP) 2.0. Total kit capacity is
32GB. Each module has been tested to run at DDR4-3600 at a
low latency timing of 17-19-19 at 1.35V. The SPDs are
programmed to JEDEC standard latency DDR4-2400
timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold
contact fingers. The JEDEC standard electrical and
mechanical specifications are as follows:
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
UL Rating
Operating Temperature
Storage Temperature
17 cycles
45.75ns(min.)
350ns(min.)
32ns(min.)
94 V - 0
0
-55
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.25V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
o
C to +85o C
o
C to +100o C
XMP TIMING PARAMETERS
•
JEDEC: DDR4-2400 CL17-17-17 @1.2V
•XMP Profile #1: DDR4-3600 CL17-19-19 @1.35V
•XMP Profile #2: DDR4-3000 CL15-17-17 @1.35V
hyperxgaming.com
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.661” (42.20mm)
Continued >>
Document No. 4808912A 04/02/19 Page 1
continued
continued HyperX
MODULE WITH HEAT SPREADER
8.3
42.2
133.35
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
133.35
129.55
2.10
±±0.15
3.00
Detail A
Pin 1
0.15
3.35
2.70
The product images shown are for illustration purposes only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without notice.
28.90
Detail B Detail D Detail C
Pin 35 Pin 47
64.60
Detail E
Pin 105 Pin 117
56.10
22.95
31.25
11.00
8.00
17.60
14.60
FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the
published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than
the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2019 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4808912A Page 2
hyperxgaming.com