HyperX HX432S20IBK2-64 User Manual

Memory Module Specifications
HX432S20IBK2/64
64GB (32GB 4G x 64-Bit x 2 pcs.) DDR4-3200 CL20 260-Pin SODIMM Kit
SPECIFICATIONS
20 cyclesCL(IDD) Row Cycle Time (tRCmin) 45.75ns (min.) Refresh to Active/Refresh 350ns (min.)
Command Time (tRFCmin) Row Active Time (tRASmin) 26.25ns (min.)
0-V49gnitaRLU Operating Temperature 0°C to 85°C Storage Temperature -55°C to +100°C
DESCRIPTION
HyperX HX432S20IBK2/64 is a kit of two 4G x 64-bit (32GB) DDR4-3200 CL20 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 2G x 8-bit DDR4 FBGA components. Each module supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. Total capacity is 64GB. This module has been tested to run at DDR4-3200 at a low latency timing of 20-22-22 at 1.2V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electri­cal and mechanical specifications are as follows:
Note: HyperX DDR4 PnP memory will run in most DDR4 systems up to the speed allowed by the manufacturer's system BIOS. PnP cannot increase the system memory speed faster than is allowed by the manufacturer's BIOS.
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-3200 CL20-22-22 @1.2V
• XMP Profile #1: DDR4-3200 CL20-22-22 @1.2V
• XMP Profile #2: DDR4-2933 CL17-19-19 @1.2V
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
hyperxgaming.com
Continued >>
Document No. 4809301A 12/12/19 Page 1
continued
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2019 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA. All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4809301A Page 2
hyperxgaming.com
Loading...