HyperX HX432S20IB2K2-16 User Manual
6
)
Memory Module Specifications
HX432S20IB2K2/16
HX432S20IB2K2/1
16GB (8GB 1G x 64-Bit x 2 pcs.)
16GB (8GB 1G x 64-Bit x 2 pcs.
DDR4-3200 CL20 260-Pin SODIMM Kit
SPECIFICATIONS
20 cyclesCL(IDD)
Row Cycle Time (tRCmin) 45.75ns (min.)
Refresh to Active/Refresh 350ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 26.25ns (min.)
Maximum Operating Power TBD W*
0 - V 49gnitaR LU
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C
*Power will vary depending on the SDRAM used.
DESCRIPTION
HyperX HX432S20IB2K2/16 is a kit of two 1G x 64-bit (8GB)
DDR4-3200 CL20 SDRAM (Synchronous DRAM) 1Rx8, memory
module, based on eight 1G x 8-bit DDR4 FBGA components.
Each module supports Intel® Extreme Memory Profiles (Intel®
XMP) 2.0. Total capacity is 16GB. This module has been
tested to run at DDR4-3200 at a low latency timing of 20-22-22
at 1.2V. Additional timing parameters are shown in the PnP
Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-3200 CL20-22-22 @1.2V
• XMP Profile #1: DDR4-3200 CL20-22-22 @1.2V
• XMP Profile #2: DDR4-2933 CL17-19-19 @1.2V
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
hyperxgaming.com
Continued >>
Document No. 4808596A 02/14/18 Page 1
continued
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
The product images shown are for illustration purposes only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without notice.
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2018 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4808596A Page 2
hyperxgaming.com
Loading...