HyperX HX432S20IB-16 User Manual

Memory Module Specifications

HX432S20IB/16

HX432S20IB/1

16GB 2G x 64-Bit

16GB 2G x 64-Bi DDR4-3200 CL20 260-Pin SODIMM

SPECIFICATIONS

20 cyclesCL(IDD) Row Cycle Time (tRCmin) 45.75ns (min.) Refresh to Active/Refresh 350ns (min.)

Command Time (tRFCmin) Row Active Time (tRASmin) 26.25ns (min.) Maximum Operating Power TBD W*

0 - V 49gnitaR LU Operating Temperature 0°C to 85°C Storage Temperature -55°C to +100°C

*Power will vary depending on the SDRAM used.

DESCRIPTION

HyperX HX432S20IB/16 is a 2 G x 64-bit (16GB) DDR4-3200 CL20 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 1G x 8-bit DDR4 FBGA components. Each module supports Intel® Extreme Memory Profiles (Intel® XMP)

2.0. This module has been tested to run at DDR4-3200 at a low latency timing of 20-22-22 at 1.2V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:

Note: HyperX DDR4 PnP memory will run in most DDR4 systems up to the speed allowed by the manufacturer's system BIOS. PnP cannot increase the system memory speed faster than is allowed by the manufacturer's BIOS.

PnP JEDEC TIMING PARAMETERS:

• JEDEC/PnP: DDR4-3200 CL20-22-22 @1.2V

• XMP Profile #1: DDR4-3200 CL20-22-22 @1.2V

• XMP Profile #2: DDR4-2933 CL17-19-19 @1.2V

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP = 2.5V Typical

• VDDSPD = 2.2V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.18” (30.00mm)

hyperxgaming.com

Continued >>

Document No. 4808563A 02/14/18 Page 1

continued

MODULE DIMENSIONS

All measurements are in millimeters.

(Tolerances on all dimensions are ±0.12 unless otherwise specified)

The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.

FOR MORE INFORMATION, GO TO HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

Document No. 4808563A Page 2

hyperxgaming.com