hyperx HX432C16PB3K2-16 User Manual

6

)

Memory Module Specifications

HX432C16PB3K2/16

HX432C16PB3K2/1

16GB (8GB 1G x 64-Bit x 2 pcs.)

16GB (8GB 1G x 64-Bit x 2 pcs.
DDR4-3200 CL16 288-Pin DIMM

SPECIFICATIONS

DESCRIPTION

HyperX HX432C16PB3K2/16 is a kit of two 1G x 64-bit (8GB)
DDR4-3200 CL16 SDRAM (Synchronous DRAM) 1Rx8,
memory module, based on eight 1G x 8-bit FBGA components
per module. Each module kit supports Intel® Extreme
Memory Profiles (Intel® XMP) 2.0. Total kit capacity is
16GB. Each module has been tested to run at DDR4-3200 at a
low latency timing of 16-18-18 at 1.35V. The SPDs are
programmed to JEDEC standard latency DDR4-2400
timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold
contact fingers. The JEDEC standard electrical and
mechanical specifications are as follows:

CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh

Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature

*Power will vary depending on the SDRAM used.

17 cycles

45.75ns(min.)
350ns(min.)

32ns(min.)
TBD W*
94 V - 0

o

C to +85o C

0

o

C to +100o C

-55

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP - 2.5V Typical

• VDDSPD = 2.25V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

XMP TIMING PARAMETERS

•

JEDEC: DDR4-2400 CL17-17-17 @1.2V

•XMP Profile #1: DDR4-3200 CL16-18-18 @1.35V

•XMP Profile #2: DDR4-3000 CL15-17-17 @1.35V

hyperxgaming.com

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.661” (42.20mm)

Continued >>

Document No. 4807788-001.A00 05/26/16 Page 1

±

continued

continued HyperX

MODULE WITH HEAT SPREADER

8.3

42.2

133.35

MODULE DIMENSIONS

133.35

129.55

2.10

±±0.15

3.00

Detail A

Pin 1

0.15

3.35

2.70

28.90

Detail B Detail D Detail C

Pin 35 Pin 47

64.60

Detail E

Pin 105 Pin 117

56.10

22.95

31.25

11.00

8.00

17.60

14.60

FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the
published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than
the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

©2015 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.

Document No. 4807788-001.A00 Page 2

hyperxgaming.com