hyperx HX432C16PB3-16 User Manual

6
t
Memory Module Specifications
HX432C16PB3/16
HX432C16PB3/1
16GB 2G x 64-Bit
16GB 2G x 64-Bi DDR4-3200 CL16 288-Pin DIMM
SPECIFICATIONS
DESCRIPTION
Each module kit supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. Each module has been tested to run at DDR4-3200 at a low latency timing of 16-18-18 at 1.35V. The SPDs are programmed to JEDEC standard latency DDR4-2400 timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows:
CL(IDD) Row Cycle Time (tRCmin) Refresh to Active/Refresh
Command Time (tRFCmin) Row Active Time (tRASmin) Maximum Operating Power UL Rating Operating Temperature Storage Temperature
*Power will vary depending on the SDRAM used.
17 cycles
45.75ns(min.) 350ns(min.)
32ns(min.) TBD W* 94 V - 0
o
C to +85o C
0
o
C to +100o C
-55
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
XMP TIMING PARAMETERS
JEDEC: DDR4-2400 CL17-17-17 @1.2V
XMP Profile #1: DDR4-3200 CL16-18-18 @1.35V
XMP Profile #2: DDR4-3000 CL15-17-17 @1.35V
hyperxgaming.com
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.661” (42.20mm)
Continued >>
Document No. 4808703A 07/12/18 Page 1
continued
±
continued HyperX
MODULE WITH HEAT SPREADER
8.3
42.2
133.35
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
133.35
129.55
2.10
±±0.15
3.00
Detail A
Pin 1
0.15
3.35
2.70
The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.
28.90
Detail B Detail D Detail C
Pin 35 Pin 47
64.60
Detail E
Pin 105 Pin 117
56.10
22.95
31.25
11.00
8.00
17.60
14.60
FOR MORE INFORMATION, GO TO WWW.HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2018 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA. All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4808703A Page 2
hyperxgaming.com
Loading...