hyperx HX430C15PB3K2-8 User Manual

8

8GB (4G

)

Memory Module Specifications

HX430C15PB3K2/8

HX430C15PB3K2/

8GB (4GB 512M x 64-Bit x 2 pcs.)
DDR4-3000 CL15 288-Pin DIMM

B 512M x 64-Bit x 2 pcs.

SPECIFICATIONS

DESCRIPTION

HyperX HX430C15PB3K2/8 is a kit of two 512M x 64-bit (4GB)
DDR4-3000 CL15 SDRAM (Synchronous DRAM) 1Rx8,
memory module, based on eight 512M x 8-bit FBGA
components per module. Each module kit supports Intel®
Extreme Memory Profiles (Intel® XMP) 2.0. Total kit
capacity is 8GB. Each module has been tested to run at
DDR4-3000 at a low latency timing of 15-17-17 at 1.35V. The
SPDs are programmed to JEDEC standard latency
DDR4-2400 timing of 17-17-17 at 1.2V. Each 288-pin
DIMM uses gold contact fingers. The JEDEC standard
electrical and mechanical specifications are as follows:

CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh

Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature

*Power will vary depending on the SDRAM used.

17 cycles

45.75ns(min.)
260ns(min.)

32ns(min.)
TBD W*
94 V - 0

o

C to +85o C

0

o

C to +100o C

-55

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP - 2.5V Typical

• VDDSPD = 2.25V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

XMP TIMING PARAMETERS

•

•XMP Profile #1: DDR4-3000 CL15-17-17 @1.35V

•XMP Profile #2: DDR4-2666 CL15-17-17 @1.35V

hyperxgaming.com

JEDEC: DDR4-2400 CL17-17-17 @1.2V

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.661” (42.20mm)

Continued >>

Document No. 4807785-001.A00 05/26/16 Page 1

±

continued

continued HyperX

MODULE WITH HEAT SPREADER

8.3

42.2

133.35

MODULE DIMENSIONS

133.35

129.55

2.10

±±0.15

3.00

Detail A

Pin 1

0.15

3.35

2.70

28.90

Detail B Detail D Detail C

Pin 35 Pin 47

64.60

Detail E

Pin 105 Pin 117

56.10

22.95

31.25

11.00

8.00

17.60

14.60

FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the
published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than
the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

©2015 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.

Document No. 4807785-001.A00 Page 2

hyperxgaming.com