hyperx HX430C15PB3AK4-32 User Manual

32GB (8G

)

Memory Module Specifications

HX430C15PB3AK4/32

HX430C15PB3AK4/32

32GB (8GB 1G x 64-Bit x 4 pcs.)
DDR4-3000 CL15 288-Pin DIMM Kit

B 1G x 64-Bit x 4 pcs.

SPECIFICATIONS

DESCRIPTION

HyperX HX430C15PB3AK4/32 is a kit of four 1G x 64-bit (8GB)
DDR4-3000 CL15 SDRAM (Synchronous DRAM) 1Rx8,
memory module, based on eight 1G x 8-bit FBGA components
per module. Each module kit supports Intel® Extreme

Memory Profiles (Intel® XMP) 2.0. Total capacity is
32GB. Each module has been tested to run at DDR4-3000 at a
low latency timing of 15-17-17 at 1.35V. The SPDs are
programmed to JEDEC standard latency DDR4-2400
timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold
contact fingers. The JEDEC standard electrical and
mechanical specifications are as follows:

CL(IDD)

Row Cycle Time (tRCmin)

Refresh to Active/Refresh
Command Time (tRFCmin)

Row Active Time (tRASmin)

Maximum Operating Power

UL Rating

Operating Temperature

Storage Temperature

*Power will vary depending on the SDRAM used.

17 cycles

45.75ns(min.)

350ns(min.)

32ns(min.)

TBD W*

94 V - 0

o

C to +70o C

0

o

C to +85o C

-40

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP = 2.5V Typical

• VDDSPD = 2.4V to 3.3V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

XMP TIMING PARAMETERS

•

JEDEC: DDR4-2400 CL17-17-17 @1.2V

•XMP Profile #1: DDR4-3000 CL15-17-17 @1.35V

•XMP Profile #2: DDR4-2666 CL15-17-17 @1.35V

hyperxgaming.com

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• HyperX Infrared Sync working distance 18mm

• Factory preset RGB wave lighting effect

• Height 1.661” (42.20mm)

Continued >>

Document No. 4808870A 12/19/18 Page 1

±

continued

continued HyperX

MODULE WITH HEAT SPREADER

8.0

42.2

133.35

MODULE DIMENSIONS

All measurements are in millimeters.

(Tolerances on all dimensions are ±0.12 unless otherwise specified)

133.35

129.55

2.10

±±0.15

3.00

Detail A

Pin 1

0.15

3.35

2.70

The product images shown are for illustration purposes only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without notice.

28.90

Detail B Detail D Detail C

Pin 35 Pin 47

64.60

Detail E

Pin 105 Pin 117

56.10

22.95

31.25

11.00

8.00

17.60

14.60

FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the
published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than
the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

©2018 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.

Document No. 4808870A Page 2

hyperxgaming.com