HyperX HX429S17IB-32 User Manual
32G
Memory Module Specifications
HX429S17IB/32
HX429S17IB/32
32GB 4G x 64-Bit
B 4G x 64-Bit
DDR4-2933 CL17 260-Pin SODIMM
SPECIFICATIONS
DESCRIPTION
HyperX HX429S17IB/32 is a 4G x 64-bit (32GB) DDR4-2933
CL17 SDRAM (Synchronous DRAM) 2Rx8, memory module,
based on sixteen 2G x 8-bit DDR4 FBGA components. Each
module supports Intel® Extreme Memory Profiles (Intel® XMP)
2.0. This module has been tested to run at DDR4-2933 at a low
latency timing of 17-19-19 at 1.2V. Additional timing parameters
are shown in the PnP Timing Parameters section below. The
JEDEC standard electrical and mechanical specifications are as
follows:
Note: HyperX DDR4 PnP memory will run in most DDR4 systems up to the
speed allowed by the manufacturer's system BIOS. PnP cannot increase the
system memory speed faster than is allowed by the manufacturer's BIOS.
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
UL Rating
Operating Temperature
Storage Temperature
17 cycles
45ns(min.)
350ns(min.)
26.55ns(min.)
94 V - 0
o
C to +85o C
0
o
C to +100o C
-55
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
hyperxgaming.com
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-2933 CL17-19-19 @1.2V
• XMP Profile #1: DDR4-2933 CL17-19-19 @1.2V
• XMP Profile #2: DDR4-2666 CL16-18-18 @1.2V
Continued >>
Document No. 4809304A 12/13/19 Page 1
continued
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
The product images shown are for illustration purposes only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without notice.
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2019 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4809304A Page 2
hyperxgaming.com
Loading...