HyperX HX429S17IB2K2-32 User Manual

32GB (16G

)

Memory Module Specifications

HX429S17IB2K2/32

32GB (16GB 2G x 64-Bit x 2 pcs.)

B 2G x 64-Bit x 2 pcs.

DDR4-2933 CL17 260-Pin SODIMM Kit

DESCRIPTION

HyperX HX429S17IB2K2/32 is a kit of two 2G x 64-bit (16GB)

DDR4-2933 CL17 SDRAM (Synchronous DRAM) 1Rx8, memory

module, based on eight 2G x 8-bit DDR4 FBGA components.

Each module supports Intel® Extreme Memory Profiles (Intel®

XMP) 2.0. Total capacity is 32GB. This module has been

tested to run at DDR4-2933 at a low latency timing of 17-19-19

at 1.2V. Additional timing parameters are shown in the PnP

Timing Parameters section below. The JEDEC standard electri-

cal and mechanical specifications are as follows:

Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS.

SPECIFICATIONS

17 cyclesCL(IDD)

Row Cycle Time (tRCmin) 45.75ns (min.)

Refresh to Active/Refresh 350ns (min.) Command Time (tRFCmin)

Row Active Time (tRASmin) 26.5ns (min.)

0-V49gnitaRLU

Operating Temperature 0°C to 85°C

Storage Temperature -55°C to +100°C

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP = 2.5V Typical

• VDDSPD = 2.2V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.18” (30.00mm)

PnP JEDEC TIMING PARAMETERS:

• JEDEC/PnP: DDR4-2933 CL17-19-19 @1.2V

• XMP Profile #1: DDR4-2933 CL17-19-19 @1.2V

• XMP Profile #2: DDR4-2666 CL16-18-18 @1.2V

hyperxgaming.com

Continued >>

Document No. 4809755A 10/21/20 Page 1

continued

MODULE DIMENSIONS

All measurements are in millimeters.

(Tolerances on all dimensions are ±0.12 unless otherwise specified)

The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.

FOR MORE INFORMATION, GO TO HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

Document No. 4809755A Page 2

hyperxgaming.com