HyperX HX429S17IB2-8 User Manual
8
8G
t
Memory Module Specifications
HX429S17IB2/8
HX429S17IB2/
8GB 1G x 64-Bit
B 1G x 64-Bi
DDR4-2933 CL17 260-Pin SODIMM
SPECIFICATIONS
17 cyclesCL(IDD)
Row Cycle Time (tRCmin) 45.75ns (min.)
Refresh to Active/Refresh 350ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 26.55ns (min.)
Maximum Operating Power TBD W*
0 - V 49gnitaR LU
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C
*Power will vary depending on the SDRAM used.
DESCRIPTION
HyperX HX429S17IB2/8 is a 1 G x 64-bit (8GB) DDR4-2933 CL17
SDRAM (Synchronous DRAM) 1Rx8, memory module, based on
eight 1G x 8-bit DDR4 FBGA components. Each module
supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0.
This module has been tested to run at DDR4-2933 at a low
latency timing of 17-19-19 at 1.2V. Additional timing parameters are shown in the PnP Timing Parameters section below.
The JEDEC standard electrical and mechanical specifications
are as follows:
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-2933 CL17-19-19 @1.2V
• XMP Profile #1: DDR4-2933 CL17-19-19 @1.2V
• XMP Profile #2: DDR4-2666 CL16-18-18 @1.2V
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
hyperxgaming.com
Continued >>
Document No. 4808562A 02/14/18 Page 1
continued
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
The product images shown are for illustration purposes only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without notice.
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2018 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4808562A Page 2
hyperxgaming.com
Loading...