HyperX HX429S17IB-16 User Manual

Memory Module Specifications

HX429S17IB/16

HX429S17IB/1

16GB 2G x 64-Bit

16GB 2G x 64-Bi DDR4-2933 CL17 260-Pin SODIMM

SPECIFICATIONS

17 cyclesCL(IDD) Row Cycle Time (tRCmin) 45.75ns (min.) Refresh to Active/Refresh 350ns (min.)

Command Time (tRFCmin) Row Active Time (tRASmin) 26.55ns (min.) Maximum Operating Power TBD W*

0 - V 49gnitaR LU Operating Temperature 0°C to 85°C Storage Temperature -55°C to +100°C

*Power will vary depending on the SDRAM used.

DESCRIPTION

HyperX HX429S17IB/16 is a 2 G x 64-bit (16GB) DDR4-2933 CL17 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 1G x 8-bit DDR4 FBGA components. Each module supports Intel® Extreme Memory Profiles (Intel® XMP)

2.0. This module has been tested to run at DDR4-2933 at a low latency timing of 17-19-19 at 1.2V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:

Note: HyperX DDR4 PnP memory will run in most DDR4 systems up to the speed allowed by the manufacturer's system BIOS. PnP cannot increase the system memory speed faster than is allowed by the manufacturer's BIOS.

PnP JEDEC TIMING PARAMETERS:

• JEDEC/PnP: DDR4-2933 CL17-19-19 @1.2V

• XMP Profile #1: DDR4-2933 CL17-19-19 @1.2V

• XMP Profile #2: DDR4-2666 CL16-18-18 @1.2V

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP = 2.5V Typical

• VDDSPD = 2.2V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.18” (30.00mm)

hyperxgaming.com

Continued >>

Document No. 4808561A 02/14/18 Page 1

continued

MODULE DIMENSIONS

All measurements are in millimeters.

(Tolerances on all dimensions are ±0.12 unless otherwise specified)

The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.

FOR MORE INFORMATION, GO TO HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

Document No. 4808561A Page 2

hyperxgaming.com