HyperX HX429C17FBK2-32 Technical data

32GB (16G
)
Memory Module Specifications
HX429C17FBK2/32
HX429C17FBK2/32
32GB (16GB 2G x 64-Bit x 2 pcs.) DDR4-2933 CL17 288-Pin DIMM Kit
B 2G x 64-Bit x 2 pcs.
SPECIFICATIONS
DESCRIPTION
HyperX HX429C17FB/16 is a kit of two 2G x 64-bit (16GB) DDR4-2933 CL17 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 1G x 8-bit FBGA components per module. Each module supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. Total kit capacity is 32GB. has been tested to run at DDR4-2933 at a low latency timing of 17-19-19 at 1.2V. the Plug-N-Play (PnP) Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:
Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS.
Additional timing parameters are shown in
Each module
CL(IDD) Row Cycle Time (tRCmin) Refresh to Active/Refresh
Command Time (tRFCmin) Row Active Time (tRASmin) Maximum Operating Power UL Rating Operating Temperature Storage Temperature
*Power will vary depending on the SDRAM used.
17 cycles
45.75ns(min.) 350ns(min.)
26.55ns(min.) TBD W* 94 V - 0
o
C to +85o C
0
o
C to +100o C
-55
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.340” (34.04mm), w/heatsink
JEDEC/XMP TIMING PARAMETERS
JEDEC/PnP: DDR4-2933 CL17-19-19 @1.2V
XMP Profile #1: DDR4-2933 CL17-19-19 @1.2V
XMP Profile #2: DDR4-2666 CL16-18-18 @1.2V
kingston.com/hyperx
hyperxgaming.com
Continued >>
Document No. 4808570A 02/14/18 Page 1
±
continued
MODULE WITH HEAT SPREADER
7.08 mm
133.35 mm
34.04 mm
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
133.35
129.55
2.10
±±0.15
3.00
Detail A
Pin 1
0.15
3.35
2.70
The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.
28.90
Detail B Detail D Detail C
Pin 35 Pin 47
64.60
Detail E
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2018 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA. All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Pin 105 Pin 117
56.10
22.95
31.25
11.00
8.00
17.60
14.60
Document No. 4808570A Page 2
hyperxgaming.com
Loading...