HyperX HX426S16IB-32 User Manual

32G

Memory Module Specifications

HX426S16IB/32

32GB 4G x 64-Bit

B 4G x 64-Bi

DDR4-2666 CL16 260-Pin SODIMM

SPECIFICATIONS

DESCRIPTION

HyperX HX426S16IB/32 is a 4G x 64-bit (32GB) DDR4-2666

CL16 SDRAM (Synchronous DRAM) 2Rx8, memory module,

based on sixteen 2G x 8-bit DDR4 FBGA components. Each

module supports Intel® Extreme Memory Profiles (Intel® XMP)

2.0. This module has been tested to run at DDR4-2666 at a low

latency timing of 16-18-18 at 1.2V. Additional timing parameters

are shown in the PnP Timing Parameters section below. The

JEDEC standard electrical and mechanical specifications are as

follows:

Note: HyperX DDR4 PnP memory will run in most DDR4 systems up to the speed allowed by the manufacturer's system BIOS. PnP cannot increase the system memory speed faster than is allowed by the manufacturer's BIOS.

CL(IDD)

Row Cycle Time (tRCmin)

Refresh to Active/Refresh Command Time (tRFCmin)

Row Active Time (tRASmin)

UL Rating

Operating Temperature

Storage Temperature

16 cycles

45ns(min.)

350ns(min.)

26.25ns(min.)

94 V - 0

C to +85o C

C to +100o C

-55

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP - 2.5V Typical

• VDDSPD = 2.25V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.18” (30.00mm)

hyperxgaming.com

PnP JEDEC TIMING PARAMETERS:

• JEDEC/PnP: DDR4-2666 CL16-18-18 @1.2V

• XMP Profile #1: DDR4-2666 CL16-18-18 @1.2V

Continued >>

Document No. 4809293A 12/13/19 Page 1

continued

MODULE DIMENSIONS

All measurements are in millimeters.

(Tolerances on all dimensions are ±0.12 unless otherwise specified)

The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.

FOR MORE INFORMATION, GO TO HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

Document No. 4809293A Page 2

hyperxgaming.com