HyperX HX426S15IB2K2-32 User Manual
32GB (16G
)
Memory Module Specifications
HX426S15IB2K2/32
HX426S15IB2K2/32
32GB (16GB 2G x 64-Bit x 2 pcs.)
B 2G x 64-Bit x 2 pcs.
DDR4-2666 CL15 260-Pin SODIMM Kit
DESCRIPTION
HyperX HX426S15IB2K2/32 is a kit of two 2G x 64-bit (16GB)
DDR4-2666 CL15 SDRAM (Synchronous DRAM) 2Rx8, memory
modules, based on sixteen 1G x 8-bit DDR4 FBGA components.
Total kit capacity is 16GB. Each module supports Intel®
Extreme Memory Profiles (Intel® XMP) 2.0. This module has
been tested to run at DDR4-2666 at a low latency timing of
15-17-17 at 1.2V. Additional timing parameters are shown in the
PnP Timing Parameters section below. The JEDEC standard
electrical and mechanical specifications are as follows:
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
SPECIFICATIONS
15 cyclesCL(IDD)
Row Cycle Time (tRCmin) 45ns (min.)
Refresh to Active/Refresh 350ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 26.25ns (min.)
Maximum Operating Power TBD W*
0 - V 49gnitaR LU
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C
*Power will vary depending on the SDRAM used.
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.25V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-2666 CL15-17-17 @1.2V
DDR4-2400 CL14-16-16 @1.2V
DDR4-2133 CL12-14-14 @1.2V
• XMP Profile #1: DDR4-2666 CL15-17-17 @1.2V
hyperxgaming.com
Continued >>
Document No. 4808039-001.A00 12/30/16 Page 1
continued
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2016 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4808039-001.A00 Page 2
hyperxgaming.com
Loading...