Memory Module Specifications
HX426C15PB3K2/64
HX426C15PB3K2/6
64GB (32GB 4G x 64-Bit x 2 pcs.)
DDR4-2666 CL15 288-Pin DIMM Kit
B 4G x 64-Bit x 2 pcs.
SPECIFICATIONS
DESCRIPTION
HyperX HX426C15PB3K2/64 is a kit of two 4G x 64-bit (32GB)
DDR4-2666 CL15 SDRAM (Synchronous DRAM) 2Rx8, memory
module, based on sixteen 2G x 8-bit FBGA components per module.
Each module kit supports Intel® Extreme Memory Profiles (Intel®
XMP) 2.0. Total kit capacity is 64GB. Each module has been tested
to run at DDR4-2666 at a low latency timing of 15-17-17 at 1.35V.
The SPDs are programmed to JEDEC standard latency DDR4-2400
timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact
fingers. The JEDEC standard electrical and mechanical
specifications are as follows:
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
UL Rating
Operating Temperature
Storage Temperature
17 cycles
45.75ns(min.)
350ns(min.)
32ns(min.)
94 V - 0
o
C to +85o C
0
o
C to +100o C
-55
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
XMP TIMING PARAMETERS
• Default (JEDEC): DDR4-2400 CL17-17-17 @1.2V
• XMP Profile #1: DDR4-2666 CL15-17-17 @1.35V
• XMP Profile #2: DDR4-2400 CL14-16-16 @1.35V
hyperxgaming.com
• Height 1.661” (42.20mm)
Continued >>
Document No. 4809413A 04/14/20 Page 1
continued
continued HyperX
MODULE WITH HEAT SPREADER
8.3
42.2
133.35
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
133.35
129.55
2.10
··0.15
3.00
Detail A
Pin 1
0.15
3.35
2.70
The product images shown are for illustration purposes only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without notice.
28.90
Detail B Detail D Detail C
Pin 35 Pin 47
64.60
Detail E
Pin 105 Pin 117
56.10
22.95
31.25
11.00
8.00
17.60
14.60
FOR MORE INFORMATION, GO TO WWW.HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the
published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than
the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2020 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4809413A Page 2
hyperxgaming.com