HyperX HX424S15IBK4-64 User Manual

4

64GB (16G

)

Memory Module Specifications

HX424S15IBK4/64

HX424S15IBK4/6

64GB (16GB 2G x 64-Bit x 4 pcs.)

B 2G x 64-Bit x 4 pcs.

DDR4-2400 CL15 260-Pin SODIMM Kit

DESCRIPTION

HyperX HX424S15IBK4/64 is a kit of four 2G x 64-bit (16GB)
DDR4-2400 CL15 SDRAM (Synchronous DRAM) 2Rx8, memory
module, based on sixteen 1G x 8-bit DDR4 FBGA components.
Total kit capacity is 64GB. Each module supports Intel®
Extreme Memory Profiles (Intel® XMP) 2.0. This module has
been tested to run at DDR4-2400 at a low latency timing of
15-15-15 at 1.2V. Additional timing parameters are shown in the
PnP Timing Parameters section below. The JEDEC standard
electrical and mechanical specifications are as follows:

Note: HyperX DDR4 PnP memory will run in most DDR4 systems up to the
speed allowed by the manufacturer's system BIOS. PnP cannot increase the
system memory speed faster than is allowed by the manufacturer's BIOS.
Memory overclocking is locked at 2133MHz on all mobile processors
except Core i5 and i7 quad core processors with a TDP of 45W or
greater.

SPECIFICATIONS

15 cyclesCL(IDD)
Row Cycle Time (tRCmin) 46.75ns (min.)
Refresh to Active/Refresh 350ns (min.)

Command Time (tRFCmin)
Row Active Time (tRASmin) 29.125ns (min.)
Maximum Operating Power TBD W*

0 - V 49gnitaR LU
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C

*Power will vary depending on the SDRAM used.

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP - 2.5V Typical

• VDDSPD = 2.25V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.18” (30.00mm)

PnP JEDEC TIMING PARAMETERS:

• JEDEC/PnP: DDR4-2400 CL15-15-15 @1.2V
DDR4-2133 CL14-14-14 @1.2V

• XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V

Memory overclocking is locked at 2133MHz on all Skylake mobile processors except Core i5 and i7 quad core processors
with a TDP of 45W or greater.

hyperxgaming.com

Continued >>

Document No. 4807590-001.A00 03/03/16 Page 1

continued

MODULE DIMENSIONS

FOR MORE INFORMATION, GO TO HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

©2016 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.

Document No. 4807590-001.A00 Page 2

hyperxgaming.com