Memory Module Specifications
HX424S15IBK4/16
HX424S15IBK4/1
16GB (4GB 512M x 64-Bit x 4 pcs.)
16GB (4GB 512M x 64-Bit x 4 pcs.
DDR4-2400 CL15 260-Pin SODIMM Kit
SPECIFICATIONS
15 cyclesCL(IDD)
Row Cycle Time (tRCmin) 46.75ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 29.125ns (min.)
Maximum Operating Power TBD W*
0 - V 49gnitaR LU
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C
*Power will vary depending on the SDRAM used.
DESCRIPTION
HyperX HX424S15IBK4/16 is a kit of four 512M x 64-bit (4GB)
DDR4-2400 CL15 SDRAM (Synchronous DRAM) 1Rx8, memory
modules, based on eight 512M x 8-bit DDR4 FBGA components.
Total kit capacity is 16GB. Each module supports Intel® Extreme
Memory Profiles (Intel® XMP) 2.0. This module has been tested
to run at DDR4-2400 at a low latency timing of 15-15-15 at 1.2V.
Additional timing parameters are shown in the PnP Timing
Parameters section below. The JEDEC standard electrical and
mechanical specifications are as follows:
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-2400 CL15-15-15 @1.2V
DDR4-2133 CL14-14-14 @1.2V
• XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.25V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
Memory overclocking is locked at 2133MHz on all Skylake mobile processors except Core i5 and i7 quad core processors
with a TDP of 45W or greater.
hyperxgaming.com
Document No. 4807560-001.A00 02/12/16 Page 1
Continued >>
continued
MODULE DIMENSIONS
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2015 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4807560-001.A00 Page 2
hyperxgaming.com