Memory Module Specifications
HX424S15IBK2/64
HX424S15IBK2/6
64GB (32GB 4G x 64-Bit x 2 pcs.)
B 4G x 64-Bit x 2 pcs.
DDR4-2400 CL15 260-Pin SODIMM Kit
DESCRIPTION
HyperX HX424S15IBK2/64 is a kit of two 4G x 64-bit (32GB)
DDR4-2400 CL15 SDRAM (Synchronous DRAM) 2Rx8, memory
module, based on sixteen 2G x 8-bit DDR4 FBGA components.
Total kit capacity is 64GB. Each module supports Intel®
Extreme Memory Profiles (Intel® XMP) 2.0. This module has
been tested to run at DDR4-2400 at a low latency timing of
15-15-15 at 1.2V. Additional timing parameters are shown in the
PnP Timing Parameters section below. The JEDEC standard
electrical and mechanical specifications are as follows:
Note: HyperX DDR4 PnP memory will run in most DDR4 systems up to the
speed allowed by the manufacturer's system BIOS. PnP cannot increase the
system memory speed faster than is allowed by the manufacturer's BIOS.
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
UL Rating
Operating Temperature
Storage Temperature
15 cycles
46.75ns(min.)
350ns(min.)
29.125ns(min.)
94 V - 0
o
C to +85o C
0
o
C to +100o C
-55
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.25V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-2400 CL15-15-15 @1.2V
DDR4-2133 CL14-14-14 @1.2V
• XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V
hyperxgaming.com
Continued >>
Document No. 4809291A 12/13/19 Page 1
continued
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
The product images shown are for illustration purposes only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without notice.
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2019 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4809291A Page 2
hyperxgaming.com