HyperX HX424S15IB2K4-32 User Manual

32GB (8G
)
Memory Module Specifications
HX424S15IB2K4/32
HX424S15IB2K4/32
32GB (8GB 1G x 64-Bit x 4 pcs.)
B 1G x 64-Bit x 4 pcs.
DDR4-2400 CL15 260-Pin SODIMM Kit
DESCRIPTION
HyperX HX424S15IB2K4/32 is a kit of four 1G x 64-bit (8GB) DDR4-2400 CL15 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 1G x 8-bit DDR4 FBGA components. Total kit capacity is 32GB. Each module supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. This module has been tested to run at DDR4-2400 at a low latency timing of 15-15-15 at 1.2V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:
Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS.
SPECIFICATIONS
15 cyclesCL(IDD) Row Cycle Time (tRCmin) 45.75ns (min.) Refresh to Active/Refresh 350ns (min.)
Command Time (tRFCmin) Row Active Time (tRASmin) 29.125ns (min.) Maximum Operating Power TBD W*
0 - V 49gnitaR LU Operating Temperature 0°C to 85°C Storage Temperature -55°C to +100°C
*Power will vary depending on the SDRAM used.
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.25V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-2400 CL15-15-15 @1.2V DDR4-2133 CL14-14-14 @1.2V
• XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V
hyperxgaming.com
Continued >>
Document No. 4808210-001.A00 05/24/17 Page 1
continued
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2017 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA. All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4808210-001.A00 Page 2
hyperxgaming.com
Loading...