HyperX HX424S14IBK2-8 User Manual
8
8GB (4G
)
Memory Module Specifications
HX424S14IBK2/8
HX424S14IBK2/
8GB (4GB 512M x 64-Bit x 2 pcs.)
B 512M x 64-Bit x 2 pcs.
DDR4-2400 CL14 260-Pin SODIMM Kit
DESCRIPTION
HyperX HX424S14IBK2/8 is a kit of two 512M x 64-bit (4GB)
DDR4-2400 CL14 SDRAM (Synchronous DRAM) 1Rx8, memory
modules, based on eight 512M x 8-bit DDR4 FBGA components.
Total kit capacity is 8GB. Each module supports Intel® Extreme
Memory Profiles (Intel® XMP) 2.0. This module has been tested
to run at DDR4-2400 at a low latency timing of 14-14-14 at 1.2V.
Additional timing parameters are shown in the PnP Timing
Parameters section below. The JEDEC standard electrical and
mechanical specifications are as follows:
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
SPECIFICATIONS
14 cyclesCL(IDD)
Row Cycle Time (tRCmin) 46.75ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 29.125ns (min.)
Maximum Operating Power TBD W*
0 - V 49gnitaR LU
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C
*Power will vary depending on the SDRAM used.
FEATURES
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.25V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.18” (30.00mm)
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP: DDR4-2400 CL14-14-14 @1.2V
DDR4-2133 CL13-13-13 @1.2V
• XMP Profile #1: DDR4-2400 CL14-14-14 @1.2V
hyperxgaming.com
Continued >>
Document No. 4807391-001.A00 08/25/15 Page 1
continued
MODULE DIMENSIONS
FOR MORE INFORMATION, GO TO HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2015 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.
Document No. 4807391-001.A00 Page 2
hyperxgaming.com
Loading...