HyperX HX424S14IB-4 User Manual

4

Memory Module Specifications

HX424S14IB/4

HX424S14IB/

4GB 512M x 64-Bit

4GB 512M x 64-Bit
DDR4-2400 CL14 260-Pin SODIMM

SPECIFICATIONS

14 cyclesCL(IDD)
Row Cycle Time (tRCmin) 46.75ns (min.)
Refresh to Active/Refresh 260ns (min.)

Command Time (tRFCmin)
Row Active Time (tRASmin) 29.125ns (min.)
Maximum Operating Power TBD W*

0 - V 49gnitaR LU
Operating Temperature 0°C to 85°C
Storage Temperature -55°C to +100°C

*Power will vary depending on the SDRAM used.

DESCRIPTION

HyperX HX424S14IB/4 is a 512M x 64-bit (4GB) DDR4-2400 CL14
SDRAM (Synchronous DRAM) 1Rx8, memory module, based on
eight 512M x 8-bit DDR4 FBGA components. Each module
supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. This
module has been tested to run at DDR4-2400 at a low latency
timing of 14-14-14 at 1.2V. Additional timing parameters are
shown in the PnP Timing Parameters section below. The JEDEC
standard electrical and mechanical specifications are as follows:

Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.

PnP JEDEC TIMING PARAMETERS:

• JEDEC/PnP: DDR4-2400 CL14-14-14 @1.2V
DDR4-2133 CL13-13-13 @1.2V

• XMP Profile #1: DDR4-2400 CL14-14-14 @1.2V

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP - 2.5V Typical

• VDDSPD = 2.25V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.18” (30.00mm)

hyperxgaming.com

Continued >>

Document No. 4807389-001.A00 08/25/15 Page 1

continued

MODULE DIMENSIONS

FOR MORE INFORMATION, GO TO HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers

the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

©2015 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners.

Document No. 4807389-001.A00 Page 2

hyperxgaming.com