HyperX HX424S14IB2K2-16 User Manual

)

Memory Module Specifications

HX424S14IB2K2/16

HX424S14IB2K2/1

16GB (8GB 1G x 64-Bit x 2 pcs.)

16GB (8GB 1G x 64-Bit x 2 pcs. DDR4-2400 CL14 260-Pin SODIMM Kit

SPECIFICATIONS

14 cyclesCL(IDD) Row Cycle Time (tRCmin) 45.75ns (min.) Refresh to Active/Refresh 350ns (min.)

Command Time (tRFCmin) Row Active Time (tRASmin) 29.125ns (min.) Maximum Operating Power TBD W*

0 - V 49gnitaR LU Operating Temperature 0°C to 85°C Storage Temperature -55°C to +100°C

*Power will vary depending on the SDRAM used.

DESCRIPTION

HyperX HX424S14IB2K2/16 is a kit of two 1G x 64-bit (8GB) DDR4-2400 CL14 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 1G x 8-bit DDR4 FBGA components. Total kit capacity is 16GB. Each module supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. This module has been tested to run at DDR4-2400 at a low latency timing of 14-14-14 at 1.2V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:

Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS.

PnP JEDEC TIMING PARAMETERS:

• JEDEC/PnP: DDR4-2400 CL14-14-14 @1.2V DDR4-2133 CL13-13-13 @1.2V

• XMP Profile #1: DDR4-2400 CL14-14-14 @1.2V

FEATURES

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP - 2.5V Typical

• VDDSPD = 2.25V to 3.6V

• On-Die termination (ODT)

• 16 internal banks; 4 groups of 4 banks each

• Bi-Directional Differential Data Strobe

• 8 bit pre-fetch

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

• Height 1.18” (30.00mm)

hyperxgaming.com

Continued >>

Document No. 4808209-001.A00 05/24/17 Page 1

continued

MODULE DIMENSIONS

All measurements are in millimeters.

(Tolerances on all dimensions are ±0.12 unless otherwise specified)

FOR MORE INFORMATION, GO TO HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston.

Document No. 4808209-001.A00 Page 2

hyperxgaming.com