Page 1
DIGITAL SPY PEN
Operation Manual HY-DIGIP-BLK
Page 2
Thank you for purchasing the Digital Spy Pen. Please
read all instructions carefully before using and retain
this manual for future use and reference.
PACKAGE CONTENTS
• Digital Spy Pen
• USB Charging Cable
KEY FEATURES
• Ballpoint pen
• Built-in camera
• Captures videos, audio and photos
• Built-in microphone
• 4GB flash memory included
SAFETY INSTRUCTIONS
Keep the unit away from heat sources, direct sunlight,
humidity, water and any other liquids.
Do not operate the unit of it has been exposed to water,
moisture or any other liquids to prevent against electric
shock, explosion and/or injury to yourself and damage to
the unit.
Do not use the unit if it has been dropped or damaged in
any way.
Repairs to electrical equipment should only be
performed by a qualified electrician. Improper repairs
may place the user at serious risk.
Do not puncture or harm the exterior surface of the
product in any way.
Keep the unit free from dust, lint, etc.
Do not use this unit for anything other than its intended
use or purpose. Doing so may damage the device.
This product is not a toy. Keep out of reach of children.
1
Page 3
FEATURES
1. Ballpoint Pen
2. Operation Button
3. Spy Camera
4. Hidden Mic
5. USB Port
6. TF Card Slot
SPECIFICATIONS
Video format: AVI
Video encoding: M-JPEG
Video resolution: 720*480
Sound sample rate: 44khz
Charging voltage: DC-5V
Interface type: SDI 2.0
Storage support: Micro SD Card
Battery type: Lithium Polymer
1
2
3
4
5
6
2
Page 4
Switch on/off
Taking Pictures
Video Recording
Data Storage
Operating instruction
Switch on/off
1.
• Press on/off key for 2 seconds to start the device.
The green LED indicator will stay on. Device is now
in snapshot mode.
• Press and hold ON/OFF button for about 2
seconds. Green LED indicator will blink 3 times.
Device is now in video mode and will record video
file instantly.
• To turn off pen, press and hold the on/off button
for 2 second. The green LED indicator will blink once
and go off.
Note: If device does not turn off within 30 sec from
switching mode, the device will turn off
automatically.
2. Taking Pictures
In standby mode, press the on/off key. The green
light will flash 1 time, take a photo, and save it to TF
card successfully.
3. Video Recording
• In standby mode, press the on/off key for 3
seconds. The green LED flashes 3 times, and the
device will start to record.
• During video recording, the green light flashes
consistently.
• Press on/off key. The video will be saved
automatically and the pen will return to standby
mode.
4. Data Storage
When the pen is off, unscrew the pen and connect
it to your computer using the included USB cable.
System will install the device as an USB storage
device automatically. You can copy all files from
the spy pen to your desktop.
3
Page 5
Disconnecting from computer
Charging
Setting time
5. Disconnecting from computer
To disconnect pen, please click ”SAFELY REMOVE
HY-6200
HARDWARE” on the right bottom corner for the task
bar. Then “USB mass storage device” to disconnect
pen.
6. Charging
Connect to computer USB interface or charger.
During charging, the red light flashes. When the
battery is fully recharged, the red light stops
flashing. Charging may take up to 4 hours.
7. Setting time
Install micro SD card into device,
1. Turn off the camera.
2. Connect to computer.
3. Open the removable disk.
4. Select time documents and open.
To set time display:
The y and N at the end will determine if the display
will show time.
“2013.01.01 12.01.01 Y” will display time.
“2013.01.01 12.01.01 N” will not display time.
The above time string shows the time you want to
set. Pay attention to the space between
Year/Month/Day and Hours Minutes and Seconds.
4
Page 6
WARRANTY INFORMATION
The condition of this warranty and our responsibilities
under this warranty are as follows:
Supplier’s warranty is non-transferable. And this warranty is
limited to the original purchaser only.
* You must be able to prove the date of original purchase
of the unit with a dated receipt.
* The warranty is not applicable if the product has been
subject to physical abuse, improper installation, modication or repair by unauthorized third party.
* The responsibility of supplier’s products shall be limited to
the repair of replacement of the product as its sole
discretion.
* Specically exempt from any warranty are limited-life
consumable components subject to normal wear and
tear such as batteries, decorates and other accessories.
* A supplier will not take any responsibility if the failure of
the unit has resulted from accident, abuse, misuse, or any
unauthorized repair, modication or disassemble.
* Modication and repair of the unit should be done by
authorized and qualied service personnel, Center or
returned to the manufacturer.
* This warranty gives you specic legal rights, and you
may also have other rights which vary under local laws.
The following conditions comprise the requirements
and scope of our warranty conditions and do not
aect our legal and contractual warranty obligations.
We oer a warranty on our products in accordance
with the following conditions:
1) Hype™ products are covered by a 12 month
warranty. We will resolve damages or defects on Hype
™ products free of charge within 12 months of the
purchase date under the following warranty
conditions. For any damage or defect determined
later than 12 months after the purchase date, proof of
a manufacturing fault must be submitted for repair
under warranty.
2) The warranty does not cover batteries and other
parts, which are considered consumables, parts that
break easily such as glass or plastic or defects based
5
Page 7
on normal wear and tear. There is no warranty
obligation in the event of marginal dierences
compared to the target appearance and workmanship provided these have a negligible eect on the
product’s tness for use, in the event of damage
caused by chemical or electrochemical eects, by
water or generally from abnormal conditions.
3) The warranty will be performed in such a way that
we shall decide whether to repair the defective parts
or to replace them with working parts free of charge.
Hype™ reserves the right to exchange the product for
a replacement product of equal value if the product
sent in cannot be repaired within a reasonable time or
at a reasonable cost. Requests cannot be made for
repairs to be carried out on site. Parts that have been
replaced or exchanged become our property.
4) The warranty claim does not apply if repairs or other
work is carried out by unauthorized persons or if our
products are equipped with additional parts or
accessories that are not approved for our product.
5) Warranties that have been activated do not cause
the warranty period to be extended, nor do they
trigger a new warranty period. The warranty period for
any replacement parts installed ends with the warranty
period for the entire product.
6) Any other further claims are excluded, especially
those for replacement due to damage caused to the
outside of the product, provided there is no obligatory
legal liability. We therefore accept no liability for
accidental, indirect or other consequential damage of
any kind, which leads to usage restrictions, data loss,
and loss of earnings or interruption to business
Asserting a warranty claim:
1) To make use of the warranty service for hardware
issues, you must contact the Hype™ Service Center by
email at support@dglusa.com
2) Hype™ will try to diagnose and solve your problem.
If it is determined that a warranty claim exists, you will
be given an RMA number (Return Material Authorization) and will be asked to send the product to Hype™.
IMPORTANT: Hype™ will only accept parcels that have
an RMA number.
6
Page 8
Please observe the following when sending the
product:
1) Send the product suitably packaged with carriage
and insurance paid. Do not enclose any accessories
with the product (cables, chargers, manuals, etc.)
unless the Hype™ Service Center species otherwise.
2) Mark the RMA number on the outside of the
package in such a way that it is visible and clearly
legible.
3) You must enclose a copy of the sales slip as proof of
purchase.
4) Once Hype™ has received the product, it will meet
its warranty obligations in accordance with the
warranty conditions and will return the product to the
sender with carriage and insurance paid.
Service outside of warranty
Hype™ can refuse any service claim made that is not
covered by the warranty.
If Hype™ agrees to provide a service outside the
warranty, the customer will be invoiced for all repair
and transport costs. Hype™ will not accept any
packages that have not rst been approved by Hype
™ by means of an (Return Material Authorization).
FCC STATEMENT
This equipment has been tested and found to comply
with the requirements for a Class B digital device under
Part 15 of the Federal Communications Commission
(FCC) rules. These requirements are intended to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment
does case harmful interference radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures.
7
Page 9
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
Do not attempt to repair or modify this equipment.
WARNING: Changes or modications to this
equipment not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment and invalidate the
warranty claim.
8
Loading...