HYNIX HY57V641620HGLT-5I, HY57V641620HGLT-6I, HY57V641620HGLT-7I, HY57V641620HGLT-8I, HY57V641620HGLT-HI Datasheet
...
HY57V641620HG-I Series
4 Banks x 1M x 16Bit Synchronous DRAM
This document is a general product description and is subject to change without notice. Hynix Semiconductor does not assume any responsibility for use
of circuits described. No patent licenses are implied.
Rev. 1.0/Jan. 02 1
DESCRIPTION
The Hynix HY57V641620HG is a 67,108,864-bit CMOS Synchronous DRAM, ideally suited for the Mobile applications r which require
low power consumption and extended temperature range. HY57V641620HG is organized as 4banks of 1,048,576x16.
HY57V641620HG is offering fully synchronous operation referenced to a positive edge of the clock. All inputs and outputs are synchronized with the rising edge of the clock input. The data paths are internally pipelined to achieve very high bandwidth. All input and output
voltage levels are compatible with LVTTL.
Programmable options include the length of pipeline (Read latency of 2 or 3), the number of consecutive read or write cycles initiated
by a single control command (Burst length of 1,2,4,8 or Full page), and the burst count sequence(sequential or interleave). A burst of
read or write cycles in progress can be terminated by a burst terminate command or can be interrupted and replaced by a new burst
read or write command on any cycle. (This pipelined design is not restricted by a `2N` rule.)
FEATURES
• Single 3.3±0.3V power supply
Note)
• All device pins are compatible with LVTTL interface
• JEDEC standard 400mil 54pin TSOP-II with 0.8mm
of pin pitch
• All inputs and outputs referenced to positive edge of
system clock
• Data mask function by UDQM or LDQM
• Internal four banks operation
• Auto refresh and self refresh
• 4096 refresh cycles / 64ms
• Programmable Burst Length and Burst Type
- 1, 2, 4, 8 or Full page for Sequential Burst
- 1, 2, 4 or 8 for Interleave Burst
• Programmable CAS
Latency ; 2, 3 Clocks
ORDERING INFORMATION
Note : VDD(Min) of HY57V641620HG(L)T-5I/55I/6I is 3.135V
Part No. Clock Frequency Power Organization Interface Package
HY57V641620HGT-5I/55I/6I/7I 200/183/166/143MHz
Normal
4Banks x 1Mbits
x16
LVTTL 400mil 54pin TSOP II
HY57V641620HGT-KI 133MHz
HY57V641620HGT-HI 133MHz
HY57V641620HGT-8I 125MHz
HY57V641620HGT-PI 100MHz
HY57V641620HGT-SI 100MHz
HY57V641620HGLT-5I/55I/6I/7I 200/183/166/143MHz
Low power
HY57V641620HGLT-KI 133MHz
HY57V641620HGLT-HI 133MHz
HY57V641620HGLT-8I 125MHz
HY57V641620HGLT-PI 100MHz
HY57V641620HGLT-SI 100MHz
HY57V641620HG
Rev. 1.0/Jan. 02 2
PIN CONFIGURATION
PIN DESCRIPTION
PIN PIN NAME DESCRIPTION
CLK Clock
The system clock input. All other inputs are registered to the SDRAM on the
rising edge of CLK
CKE Clock Enable
Controls internal clock signal and when deactivated, the SDRAM will be one
of the states among power down, suspend or self refresh
CS
Chip Select Enables or disables all inputs except CLK, CKE and DQM
BA0,BA1 Bank Address
Selects bank to be activated during RAS
activity
Selects bank to be read/written during CAS
activity
A0 ~ A11 Address
Row Address : RA0 ~ RA11, Column Address : CA0 ~ CA7
Auto-precharge flag : A10
RAS
, CAS, WE
Row Address Strobe,
Column Address Strobe,
Write Enable
RAS
, CAS and WE define the operation
Refer function truth table for details
LDQM, UDQM Data Input/Output Mask Controls output buffers in read mode and masks input data in write mode
DQ0 ~ DQ15 Data Input/Output Multiplexed data input / output pin
V
DD/VSS Power Supply/Ground Power supply for internal circuits and input buffers
V
DDQ/VSSQ Data Output Power/Ground Power supply for output buffers
NC No Connection No connection
VSS
DQ15
V
SSQ
DQ14
DQ13
V
DDQ
DQ12
DQ11
V
SSQ
DQ10
DQ9
V
DDQ
DQ8
V
SS
NC
UDQM
CLK
CKE
NC
A11
A9
A8
A7
A6
A5
A4
V
SS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
54
53
52
51
50
49
48
47
46
45
44
43
42
41
40
39
38
37
36
35
34
33
32
31
30
29
28
VDD
DQ0
V
DDQ
DQ1
DQ2
V
SSQ
DQ3
DQ4
V
DDQ
DQ5
DQ6
V
SSQ
DQ7
V
DD
LDQM
/WE
/CAS
/RAS
/CS
BA0
BA1
A10/ AP
A0
A1
A2
A3
V
DD
54pin TSOP II
400mil x 875mil
0.8mm pin pitch
HY57V641620HG
Rev. 1.0/Jan. 02 3
FUNCTIONAL BLOCK DIAGRAM
1Mbit x 4banks x 16 I/O Synchronous DRAM
X decoders
State Machine
A0
A1
A11
BA0
BA1
Address buffers
Address
Registers
Mode Registers
Row
Pre
Decoders
Column
Pre
Decoders
Column Add
Counter
Row active
Column
Active
Burst
Counter
Data Out Control
CAS Latency
Internal Row
counter
DQ0
DQ1
DQ14
DQ15
refresh
Self refresh logic
& timer
Pipe Line Control
I/O Buffer & Logic
Bank Select
Sense AMP & I/O Gate
CLK
CKE
CS
RAS
CAS
WE
UDQM
LDQM
1Mx16 Bank 3
X decoders
X decoders
Memory
Cell
Array
Y decoders
X decoders
1Mx16 Bank 0
1Mx16 Bank 1
1Mx16 Bank 2
HY57V641620HG
Rev. 1.0/Jan. 02 4
ABSOLUTE MAXIMUM RATINGS
Note : Operation at above absolute maximum rating can adversely affect device reliability
DC OPERATING CONDITION
(TA= -40 to 85°C)
Note :
1.All voltages are referenced to V
SS = 0V
2.VDD(min) of HY57V641620HG(L)T-5I/55I/6I is 3.135V
3.V
IH (max) is acceptable 5.6V AC pulse width with ≤3ns of duration
4.V
IL (min) is acceptable -2.0V AC pulse width with ≤3ns of duration
AC OPERATING CONDITION
(TA= -40 to 85°C, VDD=3.3 ± 0.3V
Note2
, VSS=0V)
Note :
1. Output load to measure access time is equivalent to two TTL gates and one capacitor (50pF)
For details, refer to AC/DC output circuit
2.VDD(min) of HY57V641620HG(L)T-5I/55I/6I is 3.135V
Parameter Symbol Rating Unit
Ambient Temperature T
A -40 ~ 85 °C
Storage Temperature T
STG -55 ~ 125 °C
Voltage on Any Pin relative to V
SS VIN, VOUT -1.0 ~ 4.6 V
Voltage on V
DD relative to VSS VDD, VDDQ -1.0 ~ 4.6 V
Short Circuit Output Current I
OS 50 mA
Power Dissipation P
D 1W
Soldering Temperature ⋅ Time T
SOLDER 260 ⋅ 10 °C ⋅ Sec
Parameter Symbol Min Typ. Max Unit Note
Power Supply Voltage V
DD, VDDQ 3.0 3.3 3.6 V 1,2
Input High Voltage V
IH 2.0 3.0 VDDQ + 2.0 V 1,3
Input Low Voltage V
IL VSSQ - 2.0 0 0.8 V 1,4
Parameter Symbol Value Unit Note
AC Input High / Low Level Voltage V
IH
/ V
IL
2.4/0.4 V
Input Timing Measurement Reference Level Voltage Vtrip 1.4 V
Input Rise / Fall Time tR / tF 1 ns
Output Timing Measurement Reference Level Voutref 1.4 V
Output Load Capacitance for Access Time Measurement CL 50 pF 1
Loading...