Hyline Offroad YJ LOUVERED HOOD PANEL User Manual

Proudly Made In USA

Parts List

Tools Needed

Qty:

1 Hood Louver Panel 1 Steel Template 41 Nylon Locknuts 2 10-32 Pan Head Screws

Installation Instructions:

YJ Hood Louver Panel Part Number: YJ-50HLP

Ratchet

7/16” Socket

File OR Sandpaper

1/16” & 1/4” Bit

Safety Glasses

Drill

Vehicle Fitment:

1987 – 1995 Jeep Wrangler

Jig Saw OR

Cut Off Wheel

Congratulations on your purchase of the Hyline Offroad Hood Louver Panel. All of our products are completely manufactured in our facility located in Perkasie, PA. They are designed and engineered by Offroad enthusiasts just like you to be rock solid at an affordable price. Hyline Offroad would like to thank you for your recent purchase and look forward to serving you in the future.

Optional Winch Installation

Hyline Offroad Staff

T:\Hyline Offroad, LLC\Installation Instructions\YJ-50HLP\YJ-50HLP Installation Instructions.doc Page 1 of 4

REV 0 06/17/09

***BEFORE INSTALLING***

PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION

If you ordered the Hood Louver Panel raw you should paint, anodize, powder coat, etc. now before installation onto vehicle. PEEL OFF THE VINYL PROTECTANT COVERING BEFORE PAINTING OR FINISHING. If Hood Louver Panel was was ordered black powder coated your now ready to continue to step 1.

Hood Louver Panel Installation

Step 1 – As a safety precaution - Remove the hood from your vehicle before drilling or cutting. First, remove the

engine grounding strap, hood light, and/or windshield washer hose from hood, if applicable. Then unbolt the 4 bolts from the hood hinges. Hood should now be free to remove from vehicle.

Step 2 – Once the hood is removed, place the hood on a flat, solid work area. Then remove the windshield

u-shape tie down bracket and windshield bumper brackets. Brackets unbolt from under the hood.

Step 3 – Place steel template in the center of hood as seen

in (Figure 1). **Picture may vary from your Template.** Visually make sure the holes in the template are centered with the holes for the windshield tie down bracket and the template is exactly where you want it.

Step 4 – Without moving the template re-install the U-Shape tie down

bracket and tighten nuts securely, as these will hold the template in place while drilling in Step 6.

T:\Hyline Offroad, LLC\Installation Instructions\YJ-50HLP\YJ-50HLP Installation Instructions.doc Page 2 of 4

Figure 1