Hyline Offroad TJ-YJ CRAWLER FRONT BUMPER User Manual

Proudly Made In USA

Parts List

10 Flat Washers

Tools Needed

Qty:

1 Standard Front Bumper
1 Winch Plate
2 TJ Left & Right Bumper

Mounting Brackets

2 YJ Left & Right Bumper

Mounting Brackets
10 ½” Grade 8 Bolts
10 Lock Washers

Installation Instructions:

TJ/YJ Standard Front Bumper
Part Number: TJ-YJ-10SFB

Ratchet

3/8” Socket

¾” Socket

T-55 Torx Socket

Tape Measure Safety Glasses

Vehicle Fitment:

1987 – 2006 Jeep Wrangler and
Wrangler Unlimited

Congratulations on your purchase of the Hyline Offroad Standard Front Bumper. Our Bumpers are completely
manufactured in our facility located in Perkasie, PA. They are designed and engineered by Offroad enthusiasts just
like you to be rock solid at an affordable price. Hyline Offroad would like to thank you for your recent purchase
and look forward to serving you in the future.

Optional Winch Installation

Hyline Offroad Staff

T:\Hyline Offroad, LLC\Installation Instructions\TJ-YJ-10SFB\TJ-YJ-10SFB Installation Instructions.doc Page 1 of 5

REV 1 11/04/08

***IMPORTANT***

PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION

Unlike many other designs, Our ORIGINAL design allows you to install your winch AFTER installing
the bumper. So if you wanted to add a winch down the road our design allows you to do so without
removing your bumper. To install your winch after mounting the bumper follow the insturctions
starting on Page 4.

If Applicable

Front Bumper Installation

Step 1 – Remove Stock bumper by unbolting the six (6) T-55 Torx Bolts.

Two on the top of each side of the bumper and one on the
Bottom of each side. Say goodbye to that flimsy stock bumper.

Step 2 – Remove plastic factory sway bar cover by unbolting four (4) 3/8”

Bolts from each side of cover. Do Not Throw This Cover Away.

Disconnect all External Lighting

Wiring that is presently attached

to existing bumper.

Step 3 – Using tape measure, find the center point in between frame rails by

Measuring the total width from inside frame rails. Mark the center
Point. (See Figure 1)

Figure 1

T:\Hyline Offroad, LLC\Installation Instructions\TJ-YJ-10SFB\TJ-YJ-10SFB Installation Instructions.doc Page 2 of 5

REV 1 11/04/08