Hyline Offroad TJ OVERSIZED TIRE MOUNT User Manual

Proudly Made In USA

Qty:

1 TJ Oversize Tire Mount
3 Wheel Studs

Installation Instructions:

TJ Oversized Tire Mount
Part Number: TJ-20OTM

Ratchet

½” Socket

Vehicle Fitment:

Fits onto Jeep Wrangler 97-06

Congratulations on your purchase of the Hyline Offroad TJ Oversized Tire Mount.
All of our products are completely manufactured in our facility located in
Perkasie, PA. They are designed and engineered by Offroad enthusiasts just like
you to be rock solid at an affordable price. Hyline Offroad would like to thank you
for your recent purchase and look forward to serving you in the future.

Hyline Offroad Staff

Op t i o n a l Wi n c h Ins t a l l a t i o n

T:\Hyline Offroad, LLC\Installation Instructions\TJ-20OTM\TJ-20OTM Installation Instructions.doc Page 1 of 2

REV 1 2/12/2010

IMPORTANT: We do not recommend installing any tire

larger than 33” in Diameter. Doing so may

cause damage to your Jeep’s tailgate hinges.

TJ Ove r s i z e d Ti r e Mo u n t

Step 1 – Using the ½” Socket remove the existing stock tire carrier from vehicle. Remove 4 Bolts from the
tailgate. Save these bolts as you will be reusing them.

Step 2 – Cut third brake light wire as needed. If you’re installing a 2” Round LED Third Brake Light leave
the existing wire longer. If not, you can terminate the wire inside vehicle.

Step 3 – With the Hyline Oversized Tire Mount still off the Jeep, you can install the 3 wheel studs. To do
this, lay the tire mount flat on the gound with the tire on top of it. Then insert the wheel studs through the
appropriate holes. Then tighten down the lug nuts. This will draw the press fit wheel studs into the tire
mount. Remove the tire once the wheel studs are installed.

Step 4 – Install the Hyline Oversize Tire Mount onto the tailgate using the same bolts you previously
removed.

Step 5 – If installing a 2” Round LED Third Brake Light you can do so by first inserting the rubber grommet
into the hole in the center of the Hyline Oversized Tire Mount, then push in the LED Light and wire.

Send your OFFROAD pictures to [e-mail] . If we choose any one of your pictures to be
used on our website, We send you a FREE Hyline Offroad T-Shirt.

Attention

in the vehicle. WEAR SEAT BELTS AT ALL TIMES WHEN DRIVING!

Though our products are rugged, they are primarily designed and built to enhance the appearance of the
vehicle and will not protect from death or injury in the event of an accident. Adhere to all vehicle
manufacturers specifications

T:\Hyline Offroad, LLC\Installation Instructions\TJ-20OTM\TJ-20OTM Installation Instructions.doc Page 2 of 2

Installation instructions provided must be read and followed exactly when installing

product. Failure to do so could potentially result in injury or death of any occupants

REV 1 2/12/2010