Hyline Offroad JK TUBE STEP ROCKER PANELS User Manual

Proudly Made In USA

Parts List

Tools Needed

Ratchet & Sockets

Drill

Hyline Offroad Staff

Qty:

1 Driver Rock Slider – RED Dot
1 Passenger Rock Slider – GREEN Dot
1 Driver Drill Template – RED Dot
1 Passenger Drill Template – GREEN Dot
8 3/8-16 Gr 5 Hex Nuts
8 3/8” USS Flat Washers Gr 5
8 3/8” Split Lock Washers Gr 5
4 3/8-16 Threaded U-Bolts
4 Square Plastic End Caps
8 3/8” Retaining Rings

Congratulations on your purchase of the Hyline Offroad Rock Sliders. All of our products are
completely manufactured in our facility located in Perkasie, PA. They are designed and engineered by
Offroad enthusiasts just like you to be rock solid. Hyline Offroad would like to thank you for your
recent purchase and look forward to serving you in the future.

Installation Instructions:

JK Tube Step Rocker Panel
Part Number: 400.300.110

5/8”, 9/16” 18mm &

19mm

Multi-Depth or Step

Drill Bit Recommended

3/16” & 1/2”

Vehicle Fitment:

2007-Present Jeep Wrangler
2-Door Only

Safety Glasses

Q:\Hyline Offroad, LLC\Installation Instructions\400.300.110-JK ROCK SLIDER (2 DOOR)\400.300.110 Installation Instructions.doc Page 1 of 4

REV 1 1/21/14

1. Remove any stock rock rails or factory tube steps from vehicle if equipped.

Passenger Side Installation:

Note: You will also need to remove the

factory Rubicon Rails if vehicle is

equipped with them.

2. Remove the two existing bolts from underside of frame rail. This should drop the skid plate crossmembers just

enough to slide the Passenger Side steel drill template in place. The Passenger Side Template will have a GREEN
Dot located on it.

3. Insert the Passenger Side steel drill template between skid plates and

the frame rail. Reinstall the two existing bolts and tighten.
(Figure 1)

4. You can now drill the 4 holes in the side of the frame through the

template using a 3/16” Drill Bit. Using a smaller drill bit will help
with accuracy before drilling the final size 1/2” hole size.

5. After all 4 holes are pre-drilled you can remove the template.

Then redrill all 4 holes open to 1/2”. A Multi-Depth or Step Drill
Bit is nicer for this operation because it’s shorter and will cut through

Figure 1, Template Shown is For 2 Door

the metal quicker and easier.

6. Before you install the Rock Slider onto your Jeep you may need to loosen more of the bolts on the gas tank skid plate

and transmission skid plate in order to fit the Rock Slider Brackets in between the skid plate crossmembers and frame
rail. You’ll need atleast a ¼’’ gap or more to make fitting in the Rock Slider Brackets much easier.

Q:\Hyline Offroad, LLC\Installation Instructions\400.300.110-JK ROCK SLIDER (2 DOOR)\400.300.110 Installation Instructions.doc Page 2 of 4

REV 1 1/21/14