Hyline Offroad JK STANDARD FRONT BUMPER User Manual

Proudly Made In

USA

ur purchase of the Hyline Offroad Standard Front Bumper. Our Bumpers are

completely manufactured in our facility located in Perkasie, PA. They are designed and engineered by

ne Offroad would like to

Qty:

1 Standard Front Bumper
1 Winch Plate
2 Left & Right Bumper

Mounting Brackets
8 8-32 Lock Nuts
8 8-32 Flat Washers
14 7/16-20 Grade 8 Bolts
14 7/16” Lock Washers
18 7/16” Flat Washers
4 7/16-20 Grade 8 Nuts
2 7/16-20 Weldnut Tabs

Congratulations on yo

Offroad enthusiasts just like you to be rock solid at an affordable price. Hyli
thank you for your recent purchase and look forward to serving you in the future.

Installation Instructions:

JK Standard & Crawler Front Bumper
Part Number:

Ratchet

18mm Deep Socket

6” Extention

11/16” Deep Socket

5/8” Socket

11/32” Deep Socket

Torque Wrench

JK-10SFB & JK-10CFB

5/8” Wrench

Vehicle Fitment:

2007 - Present Jeep Wrangler &
Unlimited

Phillips Screwdriver

Hyline Offroad Staff

Hyline Offroad Staff

Hyline Offroad StaffHyline Offroad Staff

T:\Hyline Offroad, LLC\Installation Instructions\JK-10SFB\JK-10SFB Installation Instructions.doc

REV 3 8/3/10

Page 1 of 5

Front Bumper Installation

PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION

ring that

Step 1 – Remove plastic factory frame rail cover by unscrewing two
plastic screws. Be careful while unscrewing these. The plastic
is very weak and is easy to strip out. You will NOT be reusing
this cover. Also remove the factory plastic air dam, which is
located underneath the bumper.

Step 2 – If your vehicle is equipped with factory fog lights you will need
to unplug them. Pull out or cut the plastic wire ties that are
holding the wires in place (3 Wire Ties) DO NOT CUT WIRES.
Then, slide stock bumper out far enough to unplug the fog lights.

Step 3 – Remove Stock bumper by unbolting the eight (8) 18mm nuts
From backside of bumper. Nuts are located on the inside and
outside of frame rails (See Figure 1 - Outside frame rails shown)
Say goodbye to that flimsy plastic stock bumper.

If Applicable

Disconnect all Aftermarket

External Lighting Wi

is presently attached to

existing bumper.

Step 4 – If applicable, Unscrew Factory Fog Lights at this point using
phillips screw driver. (4 on each light)

T:\Hyline Offroad, LLC\Installation Instructions\JK-10SFB\JK-10SFB Installation Instructions.doc

REV 3 8/3/10

Page 2 of 5

Figure 1