Hyline Offroad JK LOUVERED HOOD PANEL User Manual

Proudly Made In USA

PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION

Qty:

1 2 Piece Hood Louver Panel
1 Steel Template
46 Nylon Locknuts
2 10-32 Pan Head Screws

Installation Instructions:

JK Hood Louver Panel
Part Number: JK-50HLP

Ratchet & Sockets
3/8”, 9mm, 10mm

T-50 Torx

File OR Sandpaper

1/16”, 3/16” & 1/4” Bits

Safety Glasses Clear Rust Inhibitor

Drill

1” Hole Saw

Vehicle Fitment:

2007-Present Jeep Wrangler
2-Door & 4-Door

Jig Saw OR

Cut Off Wheel

Painters/Masking Tape

Spray

Congratulations on your purchase of the Hyline Offroad Hood Louver Panel. All of our products are
completely manufactured in our facility located in Perkasie, PA. They are designed and engineered by
Offroad enthusiasts just like you to be rock solid at an affordable price. Hyline Offroad would like to
thank you for your recent purchase and look forward to serving you in the future.

Hyline Offroad Staff

***BEFORE INSTALLING***

Q:\Hyline Offroad, LLC\Installation Instructions\JK-50HLP\JK-50HLP Installation Instructions.doc Page 1 of 5

REV 0 8/6/10

If you ordered the Hood Louver Panel raw you should paint, anodize, powder coat, etc. now
before installation onto vehicle. PEEL OFF THE VINYL PROTECTANT COVERING
BEFORE PAINTING OR FINISHING (If Necessary). If Hood Louver Panel was was ordered
black powder coated your now ready to continue to step 1.

Hood Louver Panel Installation

Step 1 – As a safety precaution - Remove the hood from your vehicle before drilling or cutting.

First, remove the engine grounding strap using 10mm Socket, hood light, and/or windshield

washer hose from hood. Then unbolt the 4 Torx bolts from the hood hinges using the T-50
Torx. Hood should now be free to remove from vehicle.

Step 2 – Once the hood is removed, place the hood on a flat, solid work area. Then remove u-shape

tie down bracket using the 9mm Socket. You do not need to remove the windshield
bumpers or the washer nozzel.

Step 3 – Place painters/masking tape either on the hood or backside of the steel template to prevent

any scratching.

Step 4 – Place one piece steel template in the center of hood as

Q:\Hyline Offroad, LLC\Installation Instructions\JK-50HLP\JK-50HLP Installation Instructions.doc Page 2 of 5

REV 0 8/6/10

Figure 1