Email:inquiry@hykolity.com Tel: (562) 456-0507
805 Sentous Ave, City of Industry, CA 91748 US
www.hykolity.com
Installation Instruction
WARNING
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions,
•
and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
•
•
Commercial installation, service and maintenance of luminaires should be performed by a qualified licensed electrician.
For the installation: If you are unsure about the installation or maintenance of the luminaires, consult a qualified
•
licensed electrician and check your local electrical code.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
•
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
•
WARNING
Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
•
Turn off the power when you perform any maintenance.
•
Verify that supply voltage is correct by comparing it with the luminaire label information.
•
•
All wiring connections should be capped with UL approved wire connectors.
CAUTION
Avoid direct eye exposure to the light source while it is on.
•
•
Account for small parts and destroy packing material, as these may be hazardous to children.
Risk of burn. Disconnect power and allow fixture to cool befor changing bulb or handing fixture.
•
NOTICE:
NOTICE:
NOTICE:
NOTICE:
Green ground screw provided in proper location.Do not relocate.
Minimum 90° supply conductors.
Specifications and dimensions subject to change without notice.
Suitable for Dry or Damp location
General Wiring Diagram
Black(Line)
120-277v
White(Neutral)
Green(Grd)
Grey(Dim-)
Purple(Dim+)
Dimming wire
to 0-10v IEC
compliant control
Blue(-)
Red(+)
Lead wire to
LED load
Installation Instruction
Email:inquiry@hykolity.com Tel: (562) 456-0507
805 Sentous Ave, City of Industry, CA 91748 US
www.hykolity.com
A
led driver cover
led driver
Housing
Safety cable
led module
lens
Concealed outlet box
A
Before installation, ensure if power supply is disconnected. Cables must be connected in accordance to
instruction and proper standing rules.
Remove product from packaging
1.
2.
Remove lens by pulling from one side of the fixture and hinge on the other
3.
Remove driver cover
For mounting, using the provided mounting holes on each end of the fixture housing.
4.
Mount per required application (surface or suspended),Appropriate hardware should be used (supplied by others).
5.
Make electrical connections according to code.
Install channel cover
6.
7.
Install lens on one side of the fixture and rotate to engage the opposite side
The Installation must be carried out by a qualified electrician.
Loading...