hygena Vince Ottoman Bed Frame Assembly Instructions Manual
Vince Ottoman Bed Frame
Assembly Instructions - Please keep for future reference
330/7281
355/4845
Important – Please read these instructions fully before starting assembly
Issue 1 - 01/12/14
eht llac ,s trap gnissim ro degamad evah ro pleh deen uoy fI Customer Helpline:
Argos = 0345 6400800
Dimensions
Depth x Width x Height
213cm x 148cm x 111cm (Double)
223cm x 163cm x 111cm (King)
1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fi ttings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Assemble the item as close
to its fi nal position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your fl oor.
• Assembly requires 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
• Please ensure children and
pets do not play in the storage
area or try to lift up the metal
frame.
• Once assembled, put mattress
on frame before pushing it down
and only lift up or push down the
metal frame with mattress on top.
Caution
• Do not fully tighten bolts until
the whole bed is assembled.
• Do not overtighten the nuts to
avoid causing damage to the
threads.
• Only use the handle to lift
and lower the bed frame to
avoid trapping fingers.
• Recommended thickness of
mattress:16-22cm.
Components - Panels
Please check you have all the panels listed below
2
Middle bar
9
Headboard
1
Left side bar
5
Front bar
7
Bottom support bar
10
Right side rail
2
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 6400800
Left side rail
3
Footboard
4
Right side bar
6
Rear bar
8
Slat x 26 (double)
11
Strap
12
Piston x 2
13
Non-woven fabric
Mattress stopper x 2
15
Corner bracket x 4
16
14
Leg
17
Slat cap x 13 (Double)
18
Slat cap x 26 (Double)
19
or x 30 (King)
or x 15 (King)
or x 30 (King)
(in the headboard storage) (2 pcs for headboard)
(2 pcs for footboard)
3
Please check you have all the fittings listed below
12mm Bolt x 4
Ruler - Use this ruler to help correctly identify the screws
A
29MM Bolt x 12
E
19mm Bolt x 8
B
I
19mm Bolt x 16
C
Nut x 4
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
110 115 120 125 130 135 140 145 150 155 160 165 170
105
34mm Bolt x 4
FD
44mm Bolt x 9
H
Hex key x 1
Components - Fittings
G
Plain washer x 4
J
Wrench x 1
Tools required
Phillips screwdriver
The bolts length is measured from the head to the point (19mm bolt sho
wn
).
Loading...