Hygena BENI CHAIRS Instruction manual

Page 1
HYGENA BENI PAIR OF CHAIRS
Assembly Instructions - Please keep for future reference
459/6118 (D)
461/0269 (D)
Dimensions
Width - 44 cm
Depth - 56 cm
Height - 86.5 cm
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Argos Aftersales Helpline: 0345 640 0800
Page 2
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
Check you have all the components and tools listed on the following pages.
plastic bags and separate them into their groups.
Keep children and animals away from the work area, small parts could choke if swallowed.
Make sure you have enough space to layout the parts before starting.
During assembly do not stand or put weight on the product, this could cause damage.
Assemble the item as close
room) as possible.
Assemble on a soft level surface to avoid damaging the
Parts of the assembly will be easier with 2 people.
To reduce the likelihood of damaging your product please ensure that your
power drill is set on a low torque setting.
Care and maintenance
Only clean using a damp cloth and mild detergent, do no use bleach or abrasive cleaners.
Handy Hints
Assemble all parts and bolts loosely during assembly, only once the product is complete should you fully tighten the bolts
From time to time check that there are no loose screws on this unit.
Regularly check and ensure
tightend properly.
This product should not be discarded with household waste. Take to your local authority waste disposal centre.
Note: if required the next page can be cut out and used as reference throughout the assembly. Keep this page with these instructions for future reference.
1
Page 3
Components - Panels
Please check you have all the panels listed below
1
Seat x 1
2
Leg x 1
2
Page 4
Components - Fittings
Note:
may be supplied than are required.
A
M6*20mm x 4
Tools󴖦required
Allen key
Ruler - Use this ruler to help correctly identify the screws
105
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
The screws length is measured from the head to the point (30mm screw shown).
110 115 120 125 130 135 140 145 150 155 160 165 170
3
Page 5
Assembly Instructions
Step 1
Fitting the leg
Use bolt to attach leg 2 to seat 1
orientation.
A
with correct
a:
1
FRONT
A
2
Step 2
Finishing the Unit
Carefully place the unit in the desired location.
Assembly is complete.
Argos Aftersales Helpline 0345 640 0800
4
Loading...