Page 1
RETRO 3 DRAWERS COFFEE TABLE
Assembly Instructions
- Please keep for future reference
213/3274
Dimensions
Width - 105cm
Depth - 50cm
Height - 45cm
Important
– Please read these instructions fully before starting assembly
Issue 1 - 26/02/14
Page 2
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages
• Remore all fitting from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts befo
starting.
re
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly may be
easier with 2 people.
• To reduce the
likely hood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• From time to time check that
there are no loose screws on
this unit.
• Reguraly check andensure
that all bolts and fittings are
tightend properly.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
1
Page 3
If you have damaged or missing components,
Components - Panels
call the Customer Helpline:
Please check you have all the panels listed below
Top Cabinet (105x50x17cm)
1
Legs x4 (4.8x34.6cm)
2
2
Page 4
Components - Fittings
Note:
may be supplied than are required.
M6x60mm Bolt x 8
Allen Key x 1
The quantities below are the correct amount to completed the assembly. In some cases more fittings
A
D
B
Spring Washer x 8
C
Washer x 8
Tools required
Ruler - Use this ruler to help correctly identify the screws
3
Ruler/tape
measure
Page 5
Assembly Instructions
Step 1
Assemble legs
a: Turn over the top
cabinet on smooth
and clean surface. Attach
legs to top cabinet
by bolts , spring
washers , washers
and Allen key . Do not
tighten the bolts.
1
2
A
B
D
1
a:
2
C
1
b: Turn over the cabinet.
Tighten all bolts.
Assembly is completed.
b:
4
Loading...