Page 1
HYGENA RETRO TABLE
Assembly Instructions - Please keep for future reference
453/8190
Dimensions
Width - 76cm
Length - 120cm
Height - 75cm
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Help line: 0345 6400800
Issue 2 - 26/11/13
Page 2
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed
on the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
•
Make sure you have enough
space to layout the parts before
starting.
•
Parts of the assembly will be easy
easier with 2 people.
Care and maintenance
• During assembly do not stand
or put weight on the product, this
could cause damage.
• Assemble the item as close to
its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• To reduce the
likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the
bolts.
• From time to time check that
there are no loose screws on
this unit.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
1
Page 3
If you have damaged or missing components,
Components - Panels
call the Customer Helpline: 0345 6400800
Please check you have all the panels listed below
Table top frame
1
(120 x76 cm)
Table leg x 4
2
(75 x8.7 cm)
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
A
50mm Bolt x 8 Spring washer x 8
D
Hex key x 1
B
C
Plain washer x 8
Ruler - Use this ruler to help correctly identify the screws
105
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
110 115 120 125 130 135 140 145 150 155 160 165 170
2
Page 4
Assembly Instructions
Step 1
Assemble table leg
Parts of the assembly will
be easier with 2 people.
Place table top frame
21
upside down on a clean
surface.
Fix table legs to table
top frame using bolts
A
, spring washers ,
plain washer .
22
21
B
C
Note: Re-tighten all the
bolts.
Turn the table upright.
Assembly is complete.
22
C
B
22
A
C
B
A
22
22
21
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6400800
Loading...