Page 1
Attenborough 3' Ottoman Bed
Assembly lnstructions - Please keep for future reference
hygena
402/3193
418/1499
418/6793
Dimensions (3')
Length - 203 cm
Width- 100 cm
Height - 85 cm
Important Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6400 800
Issue 1-24-06-15
Page 2
Safety and Care Advice
Check you have all the
components and tools listed on
pages 2, 3 and 4.
Remove all fittings from the
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
Assemble the item as close
to its final position (in the same
room) as possible.
Assemble on a soft level
surface to avoid damaging the
unit or your floor.
Assembly requires 2 people.
Do not fully tighten bolts until the
whole bed is assembled. Do not
overtihgten the nuts to avoid
causing damage to the threads.
From time to time check that
there are no loose screws on
this unit.
We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers and
Allen keys.
Dispose of all packaging
carefully and responsibly.
This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
Important Ottoman Safety Warnings
· Caution.This bed uses a pressurised mechanism.
· Use caution when operating - Always use two hands at arm’s length, and only where
illustrated on the product.
· You must ensure the mattress is on the bed frame before lifting the mechanism - Failure
to do so may result in injury.
· Please ensure Children and pets are kept away from the bed when operating the bed
mechanism.
· If removing the mattress, make sure that the frame is secured as it could flip open.
· Only use the storage compartment when when the frame is fully raised in the ‘up’ position.
· No children or animals are left unattended when the frame is in the ‘up’ position.
· Do not remain on the bed whilst the lifting mechanism is in use.
· Beware of Entrapment - Keep both hands clear of mechanism when operating the
mechanism.
· When lifting the bed remove all bedding - Except the fitted sheet.
v.jpg
X.jpg
1
Page 3
Components - Parts
Side rail x 2 (1930*310mm)
1
INSIDE
3
Footboard
(1000*310mm)
lf you have damaged or missing components.
call the Customer Helpline : 0345 6400 800
FRONT
Headboard
2
(1000*810mm)
Hinges (x 1 pair)
4
(750*115mm)
Base panel x 2 (600*928mm)
6
Ottoman end frame x 2
9
(910*118mm)
Piston x 2
5
(420mm)
Base panel x 1 (724*928mm)
7
10
Ottoman side frame
(1822*30mm)
Note:Extra holes
Feet x 4
8
(62*33*41.6mm)
2
Page 4
Components - Parts
11
Ottoman side frame
(1822*30mm)
lf you have damaged or missing components.
call the Customer Helpline: 0345 6400 800
12
Bentwood Slats x 14
(903*9*53mm)
Wooden support rail x 2 (930*60mm)
14
Slat caps x 28 (5.5mm)
16
13
Base Support x 4 (120*20mm)
Metal support rail x 1 (930*20mm)
15
Corner bracket x 4
17
(120*80mm)
Mattress support
18
bracket x 2
(Ø6*78mm)
3
Page 5
Components - Fittings
0345 6400 800
A
25mm M8 Bolt x 16 15mm M6 Bolt x 24
B C
D E
Nut x 4
G
4mm Allen key x 1
19mm Flat washer x 8
H
Spanner x 1
35mm M4 Wood screw x 28
F
5mm Allen key x 1
Tools required
Ruler/tape
measure
Phillips screwdriver
(Not supplied)
PLIERS (Not
supplied)
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
4
Page 6
Assembly Instructions
Attaching feet
a: Attach 2 x feet to
8
the underside of the
headboard using
screws as shown.
2
C
Repeat on the underside
of the footboard .
3
Note: The position is
outlined.
C
8
2
C
8
3
5
Page 7
Assembly Instructions
a:
Carefully place
headboard and
footboard flat on the
floor with the fixing
holes facing up.
a: Attach base supports
13
to the headboard
and footboard using
screws as shown.
Note: The positions
should be outlined.
2
3
2
3
C
C
C
13
2
13
3
b: Loosely fit bolts into
headboard and
footboard as shown.
2
3
A
b:
A
2
A
3
6
Page 8
Assembly Instructions
With help, raise the
headboard into the
standing position.
Hang the metal brackets
on the end of the side
1
rails , over the
bolts in the headboard
2
.
Note: Do not fully tighten
A
bolts at this stage.
Finger tighten only.
Repeat to assemble
footboard .
2
3
1
1
2
A
2
1
3
7
Page 9
Assembly Instructions
Preparing base
Assemble corner
a:
brackets into each
corner using screws .
Note: Ensure these are
at the same height as all
other metal support bars.
The positions should be
outlined.
17
C
b: Attach the wooden
support rails in beween
side rails using
screws .
C: Attach the metal
support rail in between
side rails using
screws .
14
1
B
15
1
B
a:
14
1
17
b:
14
1
B
c:
15
B
2
C
17
14
15
1
Finally, fully tighten all
fixing points from
previous step 3 .
Completing base
With help, carefully slide
base panels and
inside the bed frame as
shown.
6
7
8
Page 10
Assembly lnstructions
At this stage you can
choose to have the
ottoman frame lifting from
either side as shown.
Attaching folding hinges
Right opening
To lift from the right side ,
assemble hinges 4 in the
location shown .
Secure the hinges to
the headboard and
footboard using bolts
B
as shown.
3
4
2
Note: Ensure the hinges
are fitted the correct way
around as shown.
Note: The correct hole
positions should be
identified ‘R’ for right side
opening and ‘L’ for left side
opening, on both the
headboard and
footboard . The metal
folding hinges should
2
3
4
also be labelled with
corresponding ‘R’ and ‘L’
labels. Align the ‘R’ or ‘L’
markings to ensure the
correct assembly.
Opening from right side
2
4
B
R
B
3
Important
Headboard fixing holes position
R
Headboard
2
Footboard fixing holes position
Footboard
3
R
B
B
9
Page 11
Assembly lnstructions
Attaching hinges
Left opening
To lift from the left side,
assemble hinges 4 in the
location shown .
Attaching folding hinges
Secure the hinges to
headboard and
footboard using bolts
as shown.
B
2
2
Note: Ensure the hinges
are fitted the correct way
around as shown.
Note: The correct hole
positions should be
identified ‘R’ for right side
opening and ‘L’ for left side
opening, on both the
headboard and
footboard . The metal
2
3
folding hinges should
also be labelled with
corresponding ‘R’ and ‘L’
labels. Align the ‘R’ or ‘L’
markings to ensure the
correct assembly.
4
4
Opening from left side
2
4
L
B
B
Important
3
Headboard fixing holes position
2
B
Headboard
L
Footboard fixing holes position
3
B
L
Footboard
10
Page 12
Assembly Instructions
Assembling pistons
Locate pistons onto
hinges as shown.
4
Note: Ensure the"smaller"
tube is facing down as
shown.
Secure the pistons using
D
nuts at both ends.
Note: Use spanner to
tighten nut .
5
H
D
up
D
4
2
D
4
B
R
5
down
D
3
11
Page 13
Assembly Instructions
Assembling ottoman
frame
Assemble ottoman
frame components
10
and together
11
as shown.
Note: Ensure the extra
holes in side frame
are correctly located on
the inside of the frame
after assembly.
Note: Secure the
assembly using fixings
A
and as shown.
E
Important
9
10
9
A
E
9
11
10
Do not fully tighten
screws at this stage.
A
Finger tighten only.
12
Page 14
Assembly lnstructions
Attaching mattress
support brackets
18
With help, carefully turn
the frame over.
Note: The frame is heavy,
lift with care.
Assemble mattress
support brackets to
side frame using
screws .
B
18
10
Locating ottoman frame
Carefully open both
hinges to the raised
4
position.
Warning: Do not put
your hands inside the
hinges during this
operation.
18
10
B
11
B
9
With help, lift the ottoman
frame into position onto
hinges .
4
Note: The frame is heavy,
lift with care.
Secure on both sides
using screws .
B
Once assembly is
complete, fully tighten
all screws around the
ottoman frame.
4
1
B
B
4
13
Page 15
Assembly lnstructions
Attaching slats
a: Assemble slat caps
onto each end of bentwood
12
slats .
16
b: Fit the bentwood slats
12
into the ottoman side
frames and , by
locating slat caps into
the holes.
10
11
16
a:
b:
16
12
10
16
12
16
12
11
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6400 800
Home Retail Group. 489-499 Avebury Boulevard. Saxon Gate West. Central Milton Keynes. MK9 2NW
14
Loading...