Hygena 4177537 Instruction manual

Bergen 180 High gloss doors
121
121
Assembly Instructions- Please keep for future reference
DR825080
413/6633
417/7537
High gloss doors
Dimensions
Width - 180cm
Depth - 6.7cm
Height - 195.2cm
Tip : To prevent damage,
we recommend that you
build your unit on the
carton(s) it was packed in.
Dimensions
413/6633 HIGHGLOSS WHITE 417/7537 HIGHGLOSS CASH
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, please visit: www.argos-support.co.uk or email: Help@ClickSpares.co.uk (quoting your original order number) Alternatively, call the Spares Helpline on: 0370 112 1928 For any other queries please contact the Customer Helpline on: 0345 640 2020
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the components and tools listed on pages 2 and 3.
• Remove all fittings from the plastic bags and separate them into their groups.
• Keep children and animals away from the work area, small parts could choke if swallowed.
• Make sure you have enough space to layout the parts before starting.
Care and maintenance
• Only clean using a damp cloth and mild detergent, do no use bleach or abrasive cleaners.
• Do not stand or put weight on the product, this could cause damage.
• Assemble the item as close to its final position (in the same
room) as possible.
• Assemble on a soft level surface to avoid damaging the unit or your floor.
• Parts of the assembly will be easier with 2 people.
• From time to time check that there are no loose screws on this unit.
•To reduce the likelihood of damaging your product please ensure that your
power drill is set on a low torque setting.
• Dispose of all packaging carefully and responsibly.
• This product should not be discarded with household waste. Take to your local authority waste disposal centre.
Handy Hints
• Assemble all parts and bolts loosely during assembly, only once the product is complete should you fully tighten the bolts
• Regularly check and ensure
tightend properly.
Note: if required the next page can be cut out and used as reference throughout the assembly. Keep this page with these instructions for future reference.
2
Components - Panels
For damaged or missing parts, please visit: www.argos-support.co.uk or email: Help@ClickSpares.co.uk
Please check you have all the panels listed below
Cabinet supplied separately
249/4834
248/6921
226/8730
Segment x4
1
(91.5 x 65cm)
P3355
Segment middle x2
2
(91.5 x 65.1cm)
P3356
3
For damaged or missing parts, please visit:
Components - Fittings
www.argos-support.co.uk or email: Help@ClickSpares.co.uk
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
D
Screw x 72 (4x12.5mm)
S
Door handle x 3 (1951mm)
AC
FK1309
PM1652B
ZF9997L
E
Plug, Nylon x 32
T
Brush x 3 (1951mm)
A
(5x9mm)
FK1082
PM1652C
O
Connecting plate x 8
U
Door trim x 1 (1951mm)
AE
Spacer x 1
AI
FK1236
PM1652D
ZF9997F
ZF9997C
Screw x 33 (4x15mm)
AJ
Back guide part x 2
ZF9998D
AK
Sliding door connecting plate x 2
Tools required
Phillips screwdriver
(medium & large)
Drill
Flatblade screwdriver
(medium)
Piercer
(small)
Spirit level
5mm Suitable drill bit
5mm Suitable drill bit
Setsquare
Ruler - Use this ruler to help correctly identify the screws
ZF9997B
Stairs
Front guide part x 2
AL
ZF9997A
Sliding door connecting bracket x 2
Small hammer
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Ruler/tape measure
Scissors
Eye protection (when using a hammer or drill)
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
4
105
110 115 120 125 130 135 140 145 150 155 160 165 170
Loading...
+ 8 hidden pages