Hygena 4136633 Instruction manual

Bergen 180 High gloss doors

121

Assembly Instructions- Please keep for future reference

DR825080

413/6633

417/7537

High gloss doors

Dimensions

Width - 180cm

Depth - 6.7cm

Height - 195.2cm

Tip : To prevent damage,

we recommend that you

build your unit on the

carton(s) it was packed in.

Dimensions

413/6633 HIGHGLOSS WHITE 417/7537 HIGHGLOSS CASH

Important – Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline:

Argos = 0345 6400800

Issue 1 - 27/05/15

Safety and Care Advice

Important – Please read these instructions fully before starting assembly

• Check you have all the components and tools listed on pages 2 and 3.

• Remove all fittings from the plastic bags and separate them into their groups.

• Keep children and animals away from the work area, small parts could choke if swallowed.

• Make sure you have enough space to layout the parts before starting.

Care and maintenance

• Only clean using a damp cloth and mild detergent, do no use bleach or abrasive cleaners.

• Do not stand or put weight on the product, this could cause damage.

• Assemble the item as close to its final position (in the same

room) as possible.

• Assemble on a soft level surface to avoid damaging the unit or your floor.

• Parts of the assembly will be easier with 2 people.

• From time to time check that there are no loose screws on this unit.

•To reduce the likelihood of damaging your product please ensure that your

power drill is set on a low torque setting.

• Dispose of all packaging carefully and responsibly.

• This product should not be discarded with household waste. Take to your local authority waste disposal centre.

Handy Hints

• Assemble all parts and bolts loosely during assembly, only once the product is complete should you fully tighten the bolts

• Regularly check and ensure

tightend properly.

Note: if required the next page can be cut out and used as reference throughout the assembly. Keep this page with these instructions for future reference.

Components - Panels

If you have damaged or missing parts, call the

Customer Helpline:

Please check you have all the panels listed below

03456 400 800

Cabinet supplied separately

249/4834

248/6921

226/8730

Segment x4

(91.5 x 65cm)

P3355

Segment middle x2

(91.5 x 65cm)

P3356

Components - Fittings

Please check you have all the fittings listed below

Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.

Screw x 72 (4x12.5mm)

Door handle x 3 (1951mm)

FK1309

PM1652B

ZF9997L

Plug, Nylon x 32

Brush x 3 (1951mm)

(5x9mm)

FK1082

PM1652C

Connecting plate x 8

Door trim x 1 (1951mm)

Spacer x 1

FK1236

PM1652D

ZF9997F

ZF9997C

Screw x 33 (4x15mm)

Back guide part x 2

ZF9998D

Sliding door connecting plate x 2

Tools required

Phillips screwdriver

(medium & large)

Drill

Flatblade screwdriver

(medium)

Piercer

(small)

Spirit level

5mm Suitable drill bit

Setsquare

Ruler - Use this ruler to help correctly identify the screws

ZF9997B

Stairs

Front guide part x 2

ZF9997A

Sliding door connecting bracket x 2

Small hammer

0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150

0 1 2 3 4 5 6

Ruler/tape measure

Scissors

Eye protection (when using a hammer or drill)

0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100

105

110 115 120 125 130 135 140 145 150 155 160 165 170

+ 8 hidden pages